Motors (DC, stepper, servo)

HRB8825 Stepper Motor HAT For Raspberry Pi, Drives Two Stepper Motors, Up To 1/32 Microstepping Stepper Motor HAT (B) Alternative Solution Of S...

Let your robotic dreams come true with the new DC+Stepper Motor HAT from Adafruit. This Raspberry Pi add-on is perfect for any motion project as ...

3V Vertical water pump is a kind of DC micro submersible pump. Equipped with male and female Dupont line connectors, it can apply to the fountain...

Specification:Model: Mini 130 Vibration MotorMotor size: 25*20mmMotor height: 15.3mmVoltage range: DC 3V-6VRated voltage: DC 3.7VRated current: ...

This 20W adjustable DC-DC boost converter with a digital display is based on the professional boost chip and supports 3~32V power input, 5~35V ou...

This Power Module is a small size 5A 350KHz 25V Buck DC to DC Converter. It can convert any DC voltage between 3.6V-25V to a selectable voltage f...

You want to make a cool robot, maybe a hexapod walker, or maybe just a piece of art with a lot of moving parts. Or maybe you want to drive a ...

Looking for a Robot Chassis?   Check out our 2 Wheel Robot Chassis.  Perfect for adding your own electronics to.  It comes with two motors which...

This is a DC12V independent control four-way solenoid valve, which has an inlet and four air outlets, you can individually control the outlet of ea...

This is a low cost clone of the open-source EasyDriver is a simple to use stepper motor driver, compatible with anything that can output a digital ...

If you need to connect a battery pack or wired power supply to a board that has a DC jack - this adapter will come in very handy! There is a 2.1mm ...

INTRODUCTION A new micro metal gear motor with a difference! This motor comes with a built-in encoder which measures ...

What is a stepper motor? Stepper motor is a brushless DC electric motor that divides a full rotation into a number of equal steps The motor's p...

Description:Type: Emax ES08MA IISize: 23 x 11.5 x 24 mm (1.25 x.45 x.94in)Weight: 12g / 0.42ozWorking voltage: 4.8V~6.0VWorking current: 200mA/...

This cooling fan is designed for Raspberry Pi Model B+ / Raspberry Pi B. With this useful fan, you don’t need to worry about your pi becoming too h...

This DFRobot micro dual way DC motor driver is design based on TB6612FNG motor driver IC. It inherits DFRobot L298N motor control logic, which ...

The servo tester and controller can be used as a signal generator for electronic speed controllers.   If you are looking for a low-cost way to g...

This is a 9V battery pack with on/off switch and a pre-attached 5.5mm/2.1mm center-positive barrel plug. Use this to battery-power your Arduino ...

This adapter allows you to connect a barrel jack connector to bare wires. One end has screw terminals and the other has a 5.5x2.1mm, center-positiv...

Run four solenoids, two DC motors or one bi-polar or uni-polar stepper with up to 600mA per channel using the L293D. These are perhaps better kn...

If you need to add a panel-mount connection for DC power, but don't have the time or ability to cut a custom oval or square hole, this Round Pan...

These coreless motors are just right for guys who love to DIY drone models! Designed to be high performance and easy to wire, the motor can work pr...

Unlock the potential of your electronic projects with our USB Controlled Relay Module, designed for simple ON/OFF switching of electrical devices...

Note: micro:Maqueen Lite, micro:bit board and battery are not included, you can buy them separately.Use this kit to change your Maqueen Lite and Ma...