Raspberry Pi GPIO Ribbon Cable - 40-pin, 6
I give the Raspberry Pi GPIO Ribbon Cable - 40-pin, 6" (RPi 3, RPi2, B+) a rating of 5 stars!
Artem Yakimenko
SparkFun
Raspberry Pi GPIO Ribbon Cable - 40-pin, 6 (RPi 3, RPi2, B+)
All Products
New Arrivals
SparkFun
Raspberry Pi
Raspberry Pi Cables
Brands and Manufacturers
Raspberry Pi Accessories
Audio & Video
Prototyping & Wiring
$8.10
|
In stock
This 40-pin (2×20) flat ribbon cable connects to the GPIO header on the Raspberry Pi, providing easy access to all GPIO, I2C, SPI, UART, and power pins. The ...
Get notified when back in stock
Estimated Delivery
Arrives
Order within 10h 15m for same-day dispatch
Disclaimer
Secure checkout
This 40-pin (2×20) flat ribbon cable connects to the GPIO header on the Raspberry Pi, providing easy access to all GPIO, I2C, SPI, UART, and power pins. The 6-inch (15 cm) length keeps things tidy while giving you room to work with breadboards, breakout boards, and HATs.
The cable uses standard 0.1" pitch IDC connectors and is keyed for correct polarity, preventing accidental reversed connections.
Key Features
- 40-Pin (2×20) IDC – Fits the full Raspberry Pi GPIO header
- Keyed Connectors – Polarised for correct orientation
- 0.1" Pitch – Standard spacing compatible with breadboards and breakout boards
- 6-Inch Length – Compact cable for clean setups
Compatibility
- Raspberry Pi 3 Model B / B+
- Raspberry Pi 2 Model B
- Raspberry Pi Model B+
- Any board with a 40-pin GPIO header
Package Contents
- 1× 40-Pin GPIO Ribbon Cable (6 inches)
Resources
Jargon buster
Plain-language definitions for the technical terms used above.
- breakout
- A breakout board carries a small or fine-pitched component and brings its connections out to standard, breadboard- and header-friendly pins. Describing a part as a breakout means it can be wired into a project without soldering directly to the component's tiny contacts.
- GPIO
- General-purpose input/output pins are microcontroller pins you can set in software to read signals, switch devices on and off, or connect to peripherals. The number of GPIO pins matters because it limits how many buttons, LEDs, sensors, and other parts you can wire directly to the board.
- I2C
- I2C is a two-wire communication bus used by many sensors and small modules. It matters because several I2C devices can share the same two wires, but each device needs a compatible address and your controller must support I2C.
- SPI
- A fast serial communication bus often used for displays, memory cards, and sensors. It matters because SPI devices need specific pins for clock and data, plus a separate chip-select line for each device.
- UART
- UART is a simple asynchronous serial interface that sends data over separate transmit and receive wires, usually labelled TX and RX, with both ends set to the same baud rate. It is a common way for microcontrollers and other serial devices to exchange data.
Find this product in
Brands
Raspberry Pi
Raspberry Pi GPIO Ribbon Cable Datasheet
Datasheet · 504.9 KB · Click any page to view full size
Related Tutorials
Free step-by-step guides
