Little Bird
IR Infrared Obstacle Avoidance Sensor Module
All Products
Breakouts
Infrared & Thermal Sensors
New Arrivals
Sensors
Arduino
Brands and Manufacturers
Proximity & Distance
Sensors & Modules
Arduino Sensors
Sensors & Input
Prototyping & Wiring
Little Bird Electronics
$4.65
|
In stock
This IR sensor can detect obstacles in front of it. When an object is detected the green indicator light on the board will light up. There is a low-lev...
Get notified when back in stock
Estimated Delivery
Arrives
Order now — ships Mon 23 Nov
Disclaimer
Secure checkout
This IR sensor can detect obstacles in front of it. When an object is detected the green indicator light on the board will light up. There is a low-level output signal on the OUT port.
It has a detection range of 2-30 cm at an angle up to 35 degrees.
The detection distance can be changed by using the potentiometer. To increase rotate the dial clockwise.
Connect the OUT pin on the sensor module directly to you IO port.
It has a detection range of 2-30 cm at an angle up to 35 degrees.
The detection distance can be changed by using the potentiometer. To increase rotate the dial clockwise.
Connect the OUT pin on the sensor module directly to you IO port.
Connection: VCC-VCC; GND-GND; OUT-IO
Power: 3-5V
Size: 3.1CM * 1.5CM
Power: 3-5V
Size: 3.1CM * 1.5CM
Package Include:
1 x Infrared obstacle avoidance module
Find this product in
Sensors & Input
Related Tutorials
Free step-by-step guides
You might also like
Customers who bought this also bought
Arduino Infra-red obstacle sensor
$3.45
Ultrasonic Distance Sensor HC-SR04
$4.05
L298N Dual H-Bridge Motor Driver Board
$15.45
Light-dependent Resistor Sensor Module
$1.70
130 Size Hobby Motor 3-6V 4000RPM
$2.90
0.96" 7pin 128X64 OLED Display Module White
$4.95
Wheel - 65mm (Rubber Tire, Pair)
$9.10
Four - Channels Motor Shield For Arduino
$6.15
Jargon buster
Plain-language definitions for the technical terms in the product description.
- GND
- GND is the ground or reference connection (0 V) for a circuit. When connecting two devices together, their grounds must be joined so both agree on what counts as a low or high signal.
- potentiometer
- A variable resistor usually turned with a knob or shaft to create an adjustable electrical signal. It is often used for inputs such as volume, brightness or position, so it helps beginners learn how a microcontroller reads changing values.
- VCC
- VCC is the positive power-supply connection on a chip or module. Connecting it to the correct supply voltage is needed for the part to power on and helps avoid damaging the electronics.