Adafruit
5V 2A (2000mA) switching power supply - UL Listed
All Products
New Arrivals
Adafruit
Raspberry Pi
Brands and Manufacturers
Power Supplies
Arduino Power Supplies and Voltage Regulators
Raspberry Pi Accessories
$15.95
|
In stock at supplier
This FCC/CE certified and UL-listed switching power supply delivers a clean, regulated 5V DC output at up to 2A (2,000mA) via a standard 5.5×2.1mm DC barrel ...
Get notified when back in stock
Estimated Delivery
Arrives
Disclaimer
Secure checkout
This FCC/CE certified and UL-listed switching power supply delivers a clean, regulated 5V DC output at up to 2A (2,000mA) via a standard 5.5×2.1mm DC barrel jack. It accepts 110–240V AC input and is suitable for powering LED strips, motors, and other current-hungry 5V devices.
Key Features
- Output – 5V DC at up to 2A (2,000mA)
- Connector – 5.5mm OD / 2.1mm ID centre-positive DC barrel jack
- Input – 110–240V AC (universal)
- Certifications – FCC, CE, UL listed
- Stable Output – Minimal voltage droop at high currents
Compatible Accessories
- 2.1mm Barrel Jack Extension Cable (1.5m)
- Breadboard-Friendly 2.1mm DC Barrel Jack
- 2.1mm DC Barrel Jack to Alligator Clips
- 4-Way 2.1mm DC Barrel Jack Splitter
Ideal For
- Powering RGB LED strips, NeoPixels, and addressable LEDs
- Motor drivers and servo projects
- Any project requiring a dedicated 5V supply with a barrel jack
Package Contents
- 1× 5V 2A Switching Power Supply (US plug, 5.5×2.1mm DC barrel jack)
Important: This supply ships with a US plug and is not suitable for direct use in Australia. A plug adapter or replacement cable is required.
Note: This supply is not suitable for powering an Arduino via its DC jack, as the Arduino's onboard regulator requires at least 7.5V input. Use a 9V adapter for Arduino instead.
Jargon buster
Plain-language definitions for the technical terms used above.
- DC
- DC means direct current, where electricity flows in one constant direction, as supplied by batteries, USB ports and many plug-pack power supplies. When a product specifies DC, it runs from a DC supply rather than mains AC, so you need to provide the correct voltage and polarity.
- DC barrel jack
- A round power connector commonly used for low-voltage DC power supplies, often described by its outer and inner diameters such as 5.5 x 2.1 mm. Matching the barrel size and polarity is important so the plug physically fits and powers the device correctly.
- LED
- A light-emitting diode (LED) is a small electronic component that emits light when current flows through it in the correct direction. Because it only conducts one way, its polarity matters, and a through-hole LED must be soldered the correct way around to light up.
- RGB
- Short for red, green and blue, the three primary colours of light that are mixed in varying amounts to make a wide range of colours. In electronics RGB can refer to an LED or pixel that blends these three colours, or to a colour signal or interface that carries separate red, green and blue channels.
- servo
- A servo is a motor with built-in position control, usually told to move to a specific angle by a control signal. It matters when you need repeatable movement, such as steering, arms, flaps, or linkages, rather than continuous spinning.
Find this product in
All Products
Arduino Power Supplies and Voltage Regulators
New Arrivals
Power Supplies
Raspberry Pi Accessories
Brands
Related Tutorials
Free guides on learn.littlebird.com.au