DFRobot
Gravity: Flexible 8x32 RGB LED Matrix
Good news! There is a new member in to the Gravity family - The Flexible 8x32 RGB LED Matrix! This module is a square panel with a soldered XH2.54 3-pi...
Good news! There is a new member in to the Gravity family - The Flexible 8x32 RGB LED Matrix! This module is a square panel with a soldered XH2.54 3-pin interface with pin mappings that perfectly match the Arduino I/O expansion shield. This flexible 8x32 RGB full-color LED matrix module is based on WS2812 or SK6812 intelligent control LEDs. Each LED can be independently addressed with RGB pixels that can achieve 256 levels of brightness. That's 16777216 colors in total with a scanning frequency no less than 400Hz! The LED panel is single wire control board. We have customized a special cable to make it compatible with Arduino I/O expansion shields without any soldering. The module also supports cascading control. All you need to do is connect Din to the DOUT port. In combination with the open source Arduino library, you can control an entire array of LEDs using just one pin! Note: Each LED requires a maximum current of 18mA. When multiple modules are in use, it is recommended to use the DFRobot Gravity IO expansion board to power multiple LEDs matrix via the Servo Power Port.
FEATURES
SPECIFICATIONS
DOCUMENTS
SHIPPING LIST
Jargon buster
Plain-language definitions for the technical terms used above.
- DC barrel jack
- A round power connector commonly used for low-voltage DC power supplies, often described by its outer and inner diameters such as 5.5 x 2.1 mm. Matching the barrel size and polarity is important so the plug physically fits and powers the device correctly.
- DIN
- DIN means data in, the pin where this display receives data from the controller. Connecting DIN to the correct SPI data output pin is needed for the screen to receive pixel and command information.
- Gravity
- Gravity is DFRobot’s plug-in connector system for sensors, motors and modules, using standard cables to reduce loose jumper wiring. It matters because Gravity-compatible parts can connect directly to these ports, while non-Gravity parts may need adapters or manual wiring.
- LED
- A light-emitting diode is a small electronic component that lights up when current flows through it in the correct direction. In this kit, LEDs create the flashing effect, so polarity and correct soldering matter for the project to work.
- RGB
- Short for red, green and blue, usually referring to an LED that can mix those three colours. It matters because controlling an RGB LED teaches how separate outputs combine to create different colours.
- servo
- A servo is a motor with built-in position control, usually told to move to a specific angle by a control signal. It matters when you need repeatable movement, such as steering, arms, flaps, or linkages, rather than continuous spinning.
Find this product in
Brands
Components
Displays & Screens
SK6812 Datasheet
Datasheet · 440.8 KB · Click any page to view full size
Supplier page — dfrobot.com
Supplier Description · 275.0 KB · Click any page to view full size
Related Tutorials
Free guides on learn.littlebird.com.au