Sensors

SKU: DF-SEN0064 | Brand: DFRobot

A simple flex sensor 4.5" in length. As the sensor is flexed, the resistance across the sensor increases. Patented technology by Spectra Symbol - they claim these sensors were used in the original Nintendo Power Gl...

SKU: AF-2716 | Brand: Adafruit

The Adafruit SPW2430 Silicon MEMS Microphone Breakout is a compact, low-cost microphone module that detects sound and converts it to an analog voltage — no external bias resistor or amplifier needed. With a frequency ...

SKU: SF-SEN-09199 | Brand: SparkFun

The Minisense 100 from Measurement Specialties is a low-cost cantilever-type vibration sensor loaded by a mass to offer high sensitivity at low frequencies. Useful for detecting vibration and ‘tap’ inputs from a user....

SKU: PL-1479 | Brand: Pololu

This carrier board is designed to work with any of the MQ-series gas sensors, simplifying the interface from 6 to 3 pins—ground, power and analog voltage output—that are broken out with a 0.1" spacing, making the boar...

SKU: AF-2748 | Brand: Adafruit

The Adafruit ALS-PT19 is a compact analog light sensor that provides a simple voltage output proportional to ambient light intensity. Its spectral response closely matches that of the human eye, thanks to a high infra...

SKU: SF-SEN-08679 | Brand: SparkFun

A thin, flexible membrane potentiometer that senses finger or stylus position along a 200 mm strip. Pressing anywhere on the strip varies resistance linearly from 100 Ω to 10 kΩ, providing accurate positional data for...

SKU: SF-SEN-08680 | Brand: SparkFun

These are very thin variable potentiometers. By pressing down on various parts of the strip, the resistance linearly changes from 100Ohms to 10,000Ohms allowing the user to very accurately calculate the relative posit...

SKU: SF-SEN-13968 | Brand: SparkFun

The SparkFun OpenPIR is a highly customizable Passive Infrared (PIR) sensor based around the NCS36000 PIR controller. Passive infrared (PIR) sensors are able to detect motion in a small/local area –– they’re the senso...

SKU: SF-DEV-13956 | Brand: SparkFun

The SparkFun Weather Shield is an easy-to-use Arduino shield that grants you access to barometric pressure, relative humidity, luminosity and temperature. There are also connections on this shield to optional senso...

SKU: SF-SEN-00250 | Brand: SparkFun

10K thermistor with a negative temperature coefficient. Good choice for temp-sensing applications when you need a reliable NTC thermistor. Vishay part #: NTCLE100E3103JB0 Note: You get only one thermistor. Document...

SKU: AF-245 | Brand: Adafruit

The 2-Axis Joystick provides analogue input for your projects using two independent 10K potentiometers — one per axis. It reports position as either voltage or resistance, making it compatible with a wide range of mic...

SKU: AF-270 | Brand: Adafruit

A Type-K thermocouple with fiberglass braid insulation, rated to 500°C — far beyond the ~200°C limit of standard vinyl-insulated thermocouples. The bare bead probe design is suited to measuring both air and surface te...

SKU: AF-1935 | Brand: Adafruit

That's one tiny microphone! At about the size of a mature aphid, this wired Electret Microphone is perfect for your FONA. This microphone's very similar to our PCB-mount Elecret Microphone but is significantly sma...

SKU: SF-SEN-09673 | Brand: SparkFun

A compact force sensitive resistor (FSR) from Interlink Electronics with a 4 mm (0.16″) diameter active sensing area. The resistance changes based on applied pressure — from over 1 MΩ with no pressure down to approxim...

SKU: DF-DFR1132 | Brand: DFRobot

##Introduction Gravity: Linear/Analog Hall Sensor is a high-precision device designed for measuring and monitoring magnetic field strength. Advanced Hall effect circuitry at the core converts magnetic induction streng...

SKU: EF-EF05032 | Brand: ElecFreaks

An alcohol vapour sensor module from the ELECFREAKS PlanetX range, designed for use with micro:bit via an RJ11 connector. The MQ3 sensor uses a tin dioxide (SnO2) sensing element whose conductivity increases with alco...

SKU: EF-EF05018 | Brand: ElecFreaks

An analogue trimpot (trimmer potentiometer) sensor module from the ELECFREAKS PlanetX series, designed for use with micro:bit via RJ11 connection. The potentiometer provides stepless rotation over a 0°–300° range, out...

SKU: SF-SEN-24048 | Brand: SparkFun

A line follower sensor gives your robot the ability to detect lines or nearby objects. The sensor works by detecting reflected light coming from its own infrared LED. By measuring the amount of reflected infrared ligh...

SKU: SF-DEV-18426 | Brand: SparkFun

The MyoWare® 2.0 Arduino Shield is designed to easily connect up to six MyoWare 2.0 Muscle Sensors and Link Shields using 3.5mm TRS-to-TRS audio cables. The board comes pre-populated with male headers so all you would...

SKU: AF-4534 | Brand: Adafruit

The Bonsai Buckaroo is a compact add-on board for micro:bit and Adafruit CLUE that turns your board into a plant care monitoring and watering system. Bolt it on with 5 screws to get a buzzer, motor driver, and soil mo...