Sensors

SKU: AF-3942 | Brand: Adafruit

The HC-SR04 is an ultrasonic distance sensor that measures distances from approximately 2 cm to 400 cm (best results between 10–250 cm). Widely used in robotics, automation, interactive art, and motion sensing project...

SKU: AF-2340 | Brand: Adafruit

The Adafruit Capacitive Touch HAT adds 12 capacitive touch sensors to your Raspberry Pi using the MPR121 touch controller over I2C. Each sensor has a figure-8 hole designed for alligator clip connections — attach clip...

SKU: AF-2773 | Brand: Adafruit

Have your next project be controlled by your muscles with this pack of Muscle Sensor Surface EMG Electrodes! Pair the electrodes with the MyoWare Muscle Sensor and a microcontroller (ie. Arduino...

SKU: SF-BOB-08688 | Brand: SparkFun

Basic breakout board for the TEMT6000 Ambient Light Sensor. Only what you need, nothing you don’t. Sensor acts like a transistor - the greater the incoming light, the higher the analog voltage on the signal pin. Docu...

SKU: SF-SEN-08606 | Brand: SparkFun

A simple flex sensor 4.5" in length. As the sensor is flexed, the resistance across the sensor increases. Patented technology by Spectra Symbol - they claim these sensors were used in the original Nintendo Power Gl...

SKU: SF-BOB-13878 | Brand: SparkFun

The SparkFun Load Sensor Combinator is a bare PCB that combines four load sensors into a standard four-wire Wheatstone bridge configuration. If you open up an electronic bathroom scale, you’ll find a large rat’s ne...

SKU: SF-COM-00299 | Brand: SparkFun

The Texas Instruments CD74HC4067 is a 16-channel analogue multiplexer/demultiplexer IC. It allows you to route one of 16 analogue signals to a single common pin (or vice versa) using just 4 digital control lines plus ...

SKU: AF-166 | Brand: Adafruit

The Interlink 402 is a round force-sensitive resistor (FSR) with a 12.7 mm (0.5″) sensing area. It changes resistance based on applied pressure — the harder you press, the lower the resistance — making it a simple, lo...

SKU: DF-SEN0170 | Brand: DFRobot

A three-cup anemometer kit with 0–5V analog voltage output for building custom weather stations and wind monitoring systems. The aluminium alloy construction provides high strength, weather resistance, and corrosion r...

SKU: AF-3133 | Brand: Adafruit

The Adafruit Ultimate GPS FeatherWing brings precise, low-power GPS to the Feather ecosystem. Built around the MTK3339 chipset, it tracks up to 22 satellites on 66 channels with -165 dBm sensitivity and delivers up to...

SKU: SF-SEN-12969 | Brand: SparkFun

A 10-pack of disposable biomedical sensor pads (electrodes) for measuring EEG, ECG, and EMG signals. Each pad features integrated latex-free gel for strong skin adhesion and a snap connector that attaches easily to el...

SKU: AF-3290 | Brand: Adafruit

A platinum resistance temperature detector (RTD) with a 100 Ω resistance at 0°C, offering superior accuracy and long-term stability compared to thermocouples and thermistors. PT100 sensors are widely used in laborator...

SKU: DF-SEN0211 | Brand: DFRobot

INTRODUCTION When you want to measure AC current it is impractical and hazardous to cut in to your live wiring. The analog AC current sensor developed by DFRobot is a good solution to this p...

SKU: DF-SEN0208 | Brand: DFRobot

Most ultrasonic distance sensors aren't waterproof which can be a problem if you need your project to withstand the elements outdoors. No need to worry any more! We have developed waterproof ultrasonic distance senso...

SKU: DF-SEN0216 | Brand: DFRobot

The Water Flow sensor measures the rate of a liquid flowing through it. The YF-S401 water flow sensor consists of a plastic valve body, flow rotor and hall effect sensor. It is usually used at the inlet end to det...

SKU: AF-828 | Brand: Adafruit

An inline flow sensor for measuring liquid or water flow in solar heating, computer cooling, irrigation, and other fluid projects. The sensor uses a pinwheel with a magnet and an external hall effect sensor to count r...

SKU: LB-LS7682 | Brand: Little Bird

This spare outdoor unit set is designed for use with professional wireless weather stations, providing the essential sensors needed to accurately monitor local weather conditions. Ideal as a replacement set or for cus...

SKU: LB-LS1177 | Brand: Little Bird

Laser Detector Module Want to set up your own laser tripwire? These little modules make it super simple. Just hook one up to your Arduino, line it up with a laser pointer, and you’ve got a working laser detection syst...

SKU: SF-SEN-23352 | Brand: SparkFun

QR codes are a great way for users to communicate with microcontrollers, whether it’s passing WiFi credentials to set up connectivity or sending personal information to fill out a digital badge. Reading them from a ma...

SKU: DF-SEN0570 | Brand: DFRobot

Fermion: MEMS Smoke Gas Detection Sensor employs state-of-the-art microelectromechanical system (MEMS) technology, endowing the sensor with compact dimensions (13x13x2.5mm), low power consumption (<20mA), minimal heat...