Sensors & Modules

SKU: DF-TEL0117 | Brand: DFRobot

LoRa MESH Radio Module is a high performance, low power, long-range micro-power RF module, using a distributed ad-hoc network communication mode, embedded wireless MESH MANET protocols, users do not need to do any...

SKU: AF-1727 | Brand: Adafruit

The MAX31850K breakout board is a 1-Wire thermocouple amplifier with cold-junction compensation for K-type thermocouples. Unlike SPI-based amplifiers, the 1-Wire interface allows any number of thermocouple breakouts t...

SKU: AF-1733 | Brand: Adafruit

A rugged anemometer designed for outdoor wind speed measurement with a simple analog voltage output. Connect it to any microcontroller's analog input for easy wind speed readings — no complex protocols or libraries re...

SKU: AF-1032 | Brand: Adafruit

A gyroscope is a type of sensor that can sense twisting and turning motions. Often paired with an accelerometer, you can use these to do 3D motion capture and inertial measurement (that is - you can tell how an object...

SKU: AF-2024 | Brand: Adafruit

The Adafruit Capacitive Touch Shield brings 12 channels of capacitive touch sensing to any Arduino using the MPR121 chip. Each sensor has a "figure 8" pad with holes designed for quick alligator clip connections — att...

SKU: DF-SEN0006 | Brand: DFRobot

The latest model SRF05 Detection range of 3 cm from the original SRF04 -3 m, increased to 1 cm -4 meters. RF04 is compatible with the original. Also has smaller side lobes. Ultrasonic module can be used to identi...

SKU: DF-SEN0005 | Brand: DFRobot

This low cost SFR02 ultrasonic ranger has both I2C and Serial interfaces. New AutoTune algorithms intelligently back the minimum range right up to the transducer ringdown for the very best performance possible, aut...

SKU: AF-2491 | Brand: Adafruit

The ESP-12S is a compact WiFi module based on the ESP8266 processor from Espressif. Running at 80 MHz with a full WiFi front-end (client and access point modes) and built-in TCP/IP stack with DNS support, it's designe...

SKU: DF-SEN0008 | Brand: DFRobot

This small sonar ranger from Devantech offers an amazing wide range from 3cm to 6m. The SRF10 is interfaced using the IIC bus. SPECIFICATIONS Voltage-5v Current-15mA Typ. 3mA Standby Frequenc...

SKU: DF-DFR0090 | Brand: DFRobot

An 8-digit serial LED display module that uses an SPI (3-wire) interface, requiring only three I/O pins from your Arduino or microcontroller. Multiple modules can be daisy-chained together for longer displays. The fli...

SKU: AF-2460 | Brand: Adafruit

An ultra-compact passive GPS antenna measuring just 9 × 9 × 6.5 mm, with a 50 mm uFL cable. Ideal for space-constrained projects where a full-size antenna won't fit. Key Features Tiny Form Factor – Only 9 × 9 × 6.5...

SKU: DF-SEN0233 | Brand: DFRobot

A multifunction air quality monitor that measures particulate matter (PM2.5), formaldehyde concentration, temperature, and humidity. It uses laser scattering to detect suspended particles in the air, an electrochemica...

SKU: DF-DFR0117 | Brand: DFRobot

Arduino has a small amount of data storage space, The Arduino UNO has 32k. It doesn't have enough space if you want to store a lot of data. Therefore, we need to add an EEPROM Data Storage Module to increase its stora...

SKU: DF-DFR0512 | Brand: DFRobot

The MXChip Azure IoT Developer Kit is an Arduino-compatible development board designed for building cloud-connected IoT applications with Microsoft Azure. It features an STM32F412 ARM Cortex-M4F microcontroller, built...

SKU: DF-SEN0228 | Brand: DFRobot

The Gravity VEML7700 is a high-accuracy digital ambient light sensor that outputs readings directly in lux (lx) over an I²C interface. Built around the Vishay VEML7700 IC, it features a 16-bit ADC, a high-sensitivity ...

SKU: DF-DFR0130-G | Brand: DFRobot

This is a standalone DC voltage meter. It measures 3V-30V with 1% accuracy. Best suited for battery level display. Just apply two wires on the power without any extra circuit or components, it gives the reading st...

SKU: DF-DFR0130-R | Brand: DFRobot

This is a standalone DC voltage meter. It measures 3V-30V with 1% accuracy. Best suited for battery level display. Just apply two wires on the power without any extra circuit or components, it gives the reading st...

SKU: SF-COM-14325 | Brand: SparkFun

A basic 125 kHz RFID tag with a unique 40-bit ID, ideal for access control, identification, and automation projects. The tag uses the EM4001 ISO-based RFID IC with Manchester encoding. This blank, smooth, credit-card...

SKU: SF-BOB-09322 | Brand: SparkFun

A simple breakout PCB for the GP1A57HR photo interrupter (also known as a photogate, photodiode, or phototransistor). This PCB has three connections for PWR, GND, and Signal.When the gate is clear, SIG will be high (>...

SKU: SF-SEN-14282 | Brand: SparkFun

This S-Type load cell (sometimes called a strain gauge) can translate up to 200kg of pressure (force) into an electrical signal. Each load cell is able to measure the electrical resistance that changes in response and...