Sensors & Input

SKU: DF-DFR0198 | Brand: DFRobot

This is a waterproofed version of the DS18B20 Temperature sensor. Handy for when you need to measure something far away, or in wet conditions. While the sensor is good up to 125°C the cable is jacketed in PV...

SKU: LB-LR-DIGI-TEMP-1M-UA | Brand: Little Bird

The Little Bird 1-Wire Digital Temperature Sensor for Raspberry Pi — a plug-and-play solution for environment sensing, data logging, and IoT applications. Simply plug it onto the Raspberry Pi GPIO header — no breadboa...

SKU: LB-LR0007 | Brand: Little Bird

Flame Detection Sensor Module for use with Arduino Sensor for flame wavelengths between 760 nm to 1100 nm infrared is most sensitive60 degree detection sensor   Two outputs mode: AO: analog output, real-time ou...

SKU: LB-LS4690 | Brand: Little Bird

Digital temperature sensor DS18B20, waterproof case. Working range from -55 to 125 degrees. Resolution 0.5 in range from -10 up to 85 degrees.

SKU: SF-SEN-11050 | Brand: SparkFun

This sealed digital temperature probe lets you precisely measure temperatures in wet environments with a simple 1-Wire interface. The DS18B20 provides 9 to 12-bit (configurable) temperature readings over a 1-Wire i...

SKU: SF-BOB-12009 | Brand: SparkFun

The SparkFun Bi-Directional Logic Level Converter safely translates signals between different voltage levels — stepping 5V down to 3.3V and 3.3V up to 5V on the same channel. It also works with 2.8V and 1.8V devices, ...

SKU: DF-KIT0021 | Brand: DFRobot

A waterproof DS18B20 digital temperature sensor kit with everything you need to connect to an Arduino. The stainless steel probe measures temperatures from -55°C to +125°C over a 1-Wire interface, requiring just one d...

SKU: DF-SEN0189 | Brand: DFRobot

The Gravity Analog Turbidity Sensor measures water clarity by detecting the level of suspended particles. It works by measuring light transmittance and scattering rate, which change with the amount of total suspended ...

SKU: LB-LR0214-110A | Brand: Little Bird

Raspberry Pi 8 channel Level Switching (3.5V to 5V) IO Module Logic Level Converter is able to convert signals from 5V down to 3.3V (and vice versa) meaning you can safely use 5V or 3.3V devices with the Raspberry ...

SKU: SF-COM-08642 | Brand: SparkFun

This is a small device called a reed switch. When the device is exposed to a magnetic field, the two ferrous materials inside the switch pull together and the switch closes. When the magnetic field is removed, the ...

SKU: LB-LR0003 | Brand: Little Bird

This sound detection and microphone module provides both analogue and digital outputs for detecting sound with a microcontroller. The analogue output (AO) delivers a real-time voltage signal proportional to sound inte...

SKU: SF-COM-09117 | Brand: SparkFun

This is a 12-step rotary encoder with a nice ‘clicking’ feel. It’s breadboard friendly, and has a pretty handy select switch (by pushing in on the knob). The encoder is different from a potentiometer in that an enc...

SKU: AF-5715 | Brand: Adafruit

The ESP32-H2-DevKitM-1 is an entry-level development board based on the ESP32-H2-MINI-1 module, featuring Bluetooth Low Energy 5, IEEE 802.15.4, Thread, Matter, and Zigbee support on a single chip. It's an ultra-low-p...

SKU: DF-DFR0896 | Brand: DFRobot

The ESP32-S3-WROOM-1-N4 is a powerful Wi-Fi and Bluetooth LE MCU module built around the ESP32-S3 SoC. Featuring a dual-core Xtensa LX7 processor running at up to 240MHz, 4MB SPI flash, and hardware acceleration for n...

SKU: SF-SEN-18367 | Brand: SparkFun

A sealed, waterproof DS18B20 digital temperature probe for precise measurements in wet or harsh environments. The sensor communicates over a 1-Wire interface, requiring just one data pin (plus ground) to connect to yo...

SKU: AF-4007 | Brand: Adafruit

If you're like me, you've dreamed of being a dolphin - smoothly gliding through the water. Using your echo-location abilities to detect tasty fish treats. Until genetic modifications catches up with our desires, we'll...

SKU: SF-COM-10601 | Brand: SparkFun

An insulated reed switch that closes when exposed to a magnetic field and opens when the field is removed. The encapsulated design is more durable than glass reed switches and can be easily populated on a PCB. Key Fe...

SKU: DF-SEN0448 | Brand: DFRobot

A 4-wire slot-type photoelectric switch with integrated optical transmitter and receiver. The 5mm detection slot can detect objects passing through, including transparent materials, making it ideal for counting, posit...

SKU: AF-1375 | Brand: Adafruit

This breakout board is the simplest way to create a project with a single "toggle" capacitive touch sensor. No microcontroller is required here - just power with 1.8 to 5.5VDC and touch the pad to activate the sens...

SKU: DF-DFR0028 | Brand: DFRobot

This is an arduino tilt sensor. It is used to detect orientation. Inside the sensor, there is a ball that make contact with the pins when the case is upright. Tilt the sensor over and the balls don't touch, thus n...