Motors (DC, stepper, servo)

This custom-designed plastic wheel has a rubber tire measuring 1.65" (42 mm) in diameter and is designed to fit the output shafts on our mini m...

This immersible pump can be used to water your plants, make a fountain or waterfall, even change your fish tank wter.It works quietly with the ...

This tiny DC motor has a shaft with an offset mass that vibrates when it rotates. Motors like this are commonly found in cell phones and other d...

This is our new Hobby Motor now with a 6mm, 10 tooth, gear to make your basic projects a little simpler to manage. It works well for basic thing...

Tiny little servo can rotate approximately 180 degrees (90 in each direction), and works just like the standard kinds you're used to but smaller. Y...

Arduino product family is a great learning platform for electronics, programming and robotics. But most projects at some point require mobility...

This is a Gear Motor w/Encoder, model No. GB37Y3530-12V-90EN. It is a powerful 12V motor with a 90:1 metal gearbox and an integrated quadrature ...

Make an air aerial propeller vessel, a cooling system, or spinning machine with this small fan module. It comes with a propeller, a 15,000 rpm m...

INTRODUCTION A new micro metal gear motor with a difference! This motor comes with a built-in encoder which measures ...

One input: DC 6V - 12V (input voltage to the output voltage must be higher than 1V.) Output: 3.3V (+ - 0.05v error), 5.0V (+ - 0.05v error), 80...

These coreless motors are just right for guys who love to DIY drone models! Designed to be high-performance and easy to wire, the motor can work pr...

These coreless motors are just right for guys who love to DIY drone models! Designed to be high performance and easy to wire, the motor can work pr...

Ever wanted to build a small CNC router or CNC milling machine? Love working with Arduino Micro Controllers?  What projects can this be used for...

Our new design of a TB6612 motor shield, which allows us to use the most simple and effective way to drive DC motors and stepper motors, usually in...

The DG01D-E is a single hobby motor with a hall speed encoder. This motor requires a voltage between 3-9V, has a gearbox ratio of 1:48 and a spe...

But what do you do when you want to add LEGO-compatible bricks and parts to your robotics project? This is the axle you need! Just push the axle...

The Tic T500 USB Multi-Interface Stepper Motor Controller makes basic control of a stepper motor easy, with quick configuration over USB using o...

Add a power switch to any project simply by plugging this between the power supply. This is the most useful thing you never knew you needed! You'll...

This adapter allows you to connect a barrel jack connector to bare wires. One end has screw terminals and the other has a 5.5x2.1mm, center-pos...

This is a metal geared DC motor w/Encoder. It is a 6V motor with a 20:1 metal gearbox and an integrated quadrature encoder that provides a resolut...

This encoder is matched with 2wd miniQ Robot chassis. AB two-phase pulse wave,measured by two infrared reflective sensor.These two sensor pulse w...

This motor has a long (0.365" or 9.27 mm), D-shaped metal output shaft that matches the Pololu wheel 42x19mm and 32x7mm. The brass faceplate ...