Motors (DC, stepper, servo)

Specification:Model: Mini 130 Vibration MotorMotor size: 25*20mmMotor height: 15.3mmVoltage range: DC 3V-6VRated voltage: DC 3.7VRated current: ...

This 20W adjustable DC-DC boost converter with a digital display is based on the professional boost chip and supports 3~32V power input, 5~35V ou...

This is a DC12V independent control four-way solenoid valve, which has an inlet and four air outlets, you can individually control the outlet of ea...

This is a low cost clone of the open-source EasyDriver is a simple to use stepper motor driver, compatible with anything that can output a digital ...

If you need to connect a battery pack or wired power supply to a board that has a DC jack - this adapter will come in very handy! There is a 2.1mm ...

This DFRobot micro dual way DC motor driver is design based on TB6612FNG motor driver IC. It inherits DFRobot L298N motor control logic, which ...

The servo tester and controller can be used as a signal generator for electronic speed controllers.   If you are looking for a low-cost way to g...

This adapter allows you to connect a barrel jack connector to bare wires. One end has screw terminals and the other has a 5.5x2.1mm, center-positiv...

Run four solenoids, two DC motors or one bi-polar or uni-polar stepper with up to 600mA per channel using the L293D. These are perhaps better kn...

These coreless motors are just right for guys who love to DIY drone models! Designed to be high performance and easy to wire, the motor can work pr...

Unlock the potential of your electronic projects with our USB Controlled Relay Module, designed for simple ON/OFF switching of electrical devices...

Note: micro:Maqueen Lite, micro:bit board and battery are not included, you can buy them separately.Use this kit to change your Maqueen Lite and Ma...

We're keepin' it wheel with this one! Plastic gear-box motors (also known as 'TT' motors) are an easy and low cost way to get your projects movi...

 DC3V 612 6*12MM Micro DIY Helicopter Coreless DC Motor  

This adapter allows you to connect a barrel jack connector to bare wires. One end has screw terminals and the other has a 5.5x2.1mm, center-pos...

This is a Gear Motor w/Encoder, model No.GB37Y3530-12V-251R. It is a powerful 12V motor with a 43.8:1 metal gearbox and an integrated quadrature e...

This immersible pump can be used to water your plants, make a fountain or waterfall, even change your fish tank wter.It works quietly with the ...

If you need to connect a DC power wall wart to a board that doesn't have a DC jack - this adapter will come in very handy! There is a 2.1mm DC jack...

INTRODUCTION   This DC gearmotor has an integrated M4*55mm threaded rod as its output shaft, turn it into a linear actuator. 6V rated voltage...

Looking for a Robot Chassis?   Check out our 2 Wheel Robot Chassis in Blue.  Perfect for adding your own electronics to.  It comes with two moto...