Motors (DC, stepper, servo)

The NEMA 23 Stepper Motor Mount connects to the topside of a stepper motor to make integrating it into your Actobotics project even easier. Than...

The NEMA 17 Stepper Motor Mount connects to the topside of a stepper motor to make integrating it into your Actobotics project even easier. Than...

The Pololu serial 8-servo controller allows you to control up to eight RC servos with almost any robot controller or computer. Connect multiple uni...

This is the Arduino shield version of our TLC5940 Breakout. The SparkFun PWM Shield will allow you to generate up to 16 PWM signals from your Ardui...

INTRODUCTION This is a new micro DC geared motor, using planetary gear mechanism, applicable to the various types of DIY...

This is a high quality switching ‘wall wart’ AC to DC 5V 2000mA Barrel Jack wall power supply manufactured specifically for SparkFun Electronics...

The Pan-Tilt HAT from Pimoroni lets you mount and control a pan-tilt module right on top of your Raspberry Pi. The HAT and its on-board microcon...

AdaBox002 - Making Things Move with our Feather Bluetooth LE Mini Robot Rover is the perfect gift for folks who are just getting started in the ...

This power jack is designed to easily attach to a panel up to 8mm thick (0.315" or 5/16") and fit 2.1mm power plugs snugly and securely. Perfect fo...

INTRODUCTION   This is a motor revolution: a new DC brushless motor with built-in motor driver. It can be conncected to Arduino directly without...

This pan/tilt bracket consists of two brackets and all the hardware you need to attach them to make a pan/tilt mechanism using two servo motors. We...

If you’re looking for a chassis base for your next robot, look no further than the Rover 5. The Rover 5 uses 4 independent motors, each with a hall...

Here is a simple, low-cost, high quality servo for all your mechatronic needs. This servo is able to take in 6 volts and deliver 44.4 oz-in. of max...

This is a common SMD barrel-type power jack for DC wall supplies. These are compatible with our DC wall supplies and have a 5.5mm jack, with a 2.1m...

These acrylic mounts are used to attach a miniature microswitches to a slotted surface like an Actobotics channel, making the switch perfect ...

INTRODUCTION The Arduino Motor Shield is based on L298 (a dual full-bridge driver designed to drive inductive loads such...

INTRODUCTION This motor has a long (0.365"/9.27 mm) D profile metal output shaft that matches the 42x19mm and 32x7mm ...

INTRODUCTION This motor has a long (0.365"/9.27 mm) D profile metal output shaft that matches the 42x19mm and 32x7mm ...

INTRODUCTION This motor has a long (0.365"/9.27 mm) D profile metal output shaft that matches the 42x19mm and 32x7mm ...

This is essentially a ramped up version of our Ardumoto motor driver shield. For this SparkFun Monster Moto Shield we’ve replaced the L298 H-bridge...

Here, for all your mechatronic needs, is a simple, high quality continuous rotation servo motor. This servo is able to take in 6 volts and deliver ...

This powerhouse is the Hitec HS-755HB servo. Able to take in 6 volts and deliver an impressive 183 oz-in. of maximum torque at 0.23 sec/60°, this i...

INTRODUCTION A new micro metal gear motor with a difference! This motor comes with a built-in encoder which measures the motor's speed in real ...

These continuous rotation 3.8:1 gear ratio channel gearbox kits incorporate threaded side mounts to easily attach a standard size servo to numer...