Motor Drivers and Controllers

Do you need to precisely dispense amounts of liquid for your preferred beverage? If so this could be the pump for you. This is the Bartendro Dispen...

The Big Easy Driver, designed by Brian Schmalz, is a stepper motor driver board for bi-polar stepper motors up to a max 2A/phase. It is based on...

Have you ever wanted to control the flow of a liquid using your computer or microcontroller, but didn’t know how? Well, here’s how: The 12V solenoi...

The Pan-Tilt HAT from Pimoroni lets you mount and control a pan-tilt module right on top of your Raspberry Pi. The HAT and its on-board microcon...

The SparkFun EL Sequencer is a board that contains an Arduino-compatible microcontroller, and circuitry for controlling up to eight strands of elec...

The EasyDriver is a simple to use stepper motor driver, compatible with anything that can output a digital 0 to 5V pulse (or 0 to 3.3V pulse if you...

INTRODUCTION The RLY-8 is a network relay controller with open source communication protocol. It integrates 8 channel...

INTRODUCTION The Arduino Motor Shield is based on L298 (a dual full-bridge driver designed to drive inductive loads such...

This touch controller set is a quick and easy way to control a bunch of our 12V analog RGB LED strip. The box part contains power driver circuit...

A voltage detector is handy for projects where you want to make sure your microcontroller doesn't run at a low voltage. For example, say you hav...

Pocket-sized fun is the name of this game, with the Joy Bonnet – our most fun Bonnet ever (no we didn't even think that was possible, either!...

Knobs are a great way to finish off your project and make it easier to adjust the level of your death ray. This knob mates to a 0.25" shaft with a ...

Add knobs to your grid with this add-on accessory for the UNTZtrument. This is a replacement piece of laser cut acrylic to use when building an ...

Welcome to CurieBot, your own mobile, customizable, and adorable, 32-bit, Bluetooth-enabled driving robot! Based upon our popular three-layer ro...

This Panel Mount 10K Dual Linear Potentiometer is a dual-ganged potentiometer that will satisfy all your stereo-signal needs. Instead of just on...

This is a generic Wii Nunchuck controller, we haven't tried it with a Wii but it does work great with the Video Game shield, and all the microco...

Build and customize your very own open-source button grid controller based on the Adafruit Trellis with the UNTZtrument kit HELLA UNTZtrument KI...

INTRODUCTION This is an ultra small size DC motor driver for room limited projects, while the impressive IC - LM2575 ...

These clamping hubs are a great and cost-effective choice when attaching hub mount gears or wheels to shafts or tubes and can be a better option...

This is a 4.8-46V, 2A Dual Motor Controller which is the revised version of the DF-MDV1.0. Its performance has been improved greatly. It can bear ...

INTRODUCTION The latest quad motor driver shield for Arduino, compatible with 5V/3.3V Arduino controller, can control up...

Arduino product family is a great learning platform for electronics, programming and robotics. But most projects at some point require mobility...

This is an ultra small Dual DC motor driver for some room limited projects. UVLO (Under Voltage Latch-Out) features a safe guard for your system...

This dual bidirectional motor driver, from Cana Kit, is based on the very popular L298 Dual H-Bridge Motor Driver Integrated Circuit. The circui...