DIY Project Kits

This is a black plastic bezel, custom made to mate with the silicon rubber pads. Black 1/8" ABS plastic. Using two of these bezels with two of t...

These micro gearmotors are incredibly tough and feature full metal gears. They have a gear ratio of 250:1 and operate up to 12 volts and have a ...

Solder wick, coffee, and paper towels keep SparkFun running. You can steal someone’s diagonal cutters for a minute, but you’d better ask before tou...

This is a black plastic bezel, custom made to mate with the silicon rubber pads. Black 1/8" ABS plastic. We use four 4/40-0.5" size screws match...

ΩMG! You're not going to be able to resist these handy resistor packs! Well, axially, they do all of the resisting for you!These are  25 Packs of R...

Complete your Pi setup with our custom designed faceplate specifically designed to fit your 2.8" PiTFT and Adafruit Pi B+ / Pi 2 case base! This...

This is a SOP8/SOP16/SOP28 to DIP16/DIP28 Adapter Board.You can change the SOP8/SOP16/SOP28 to DIP16/DIP28 packaging. So that You needn't to buy...

These servo gears are made specifically to fit a Hitec C1 servo spline, allowing you to mate other gears to your servo. They have 20 teeth with ...

SPECIFICATIONS Type: LM6UU Inner diameter: 6mm (0.24") Outer diameter: 12mm (0.47") Length: 35mm (1.38") SHIPPI...

These stainless steel shaft couplers allow you to couple two size shafts together. They can be used for connecting motor shafts to drive shafts,...

The STEMTera is an innovation in breadboard history. It is the first breadboard with an Arduino-compatible hardware suite built in that works with ...

This is 1 meter of PFA tubing with a 6mm diameter. PFA has a high temperature resistance with a melting point of 305C. This tubing is used as a bo...

These blue precision disk wheels have an outer diameter of 5”, a width of 0.23”, and utilize the 0.77” hub pattern. These simple wheels are idea...

Two pin JST connector to a 2.1x 5.5mm barrel jack, 6.25 inch long jumper cable. We use this cable to adapt from a wall power supply to a relativ...

These 2" long stainless steel shafts have a diameter of 3/8". These shafts are solid, which makes them an ideal choice for axles. These shafts have...

Screw plates make it easy to create a strong joining point between our channel pieces. Te small screw plate is 0.784" square, has 4 6-32 tapped ...

This is a piezoresistive force sensor. The harder you press, the lower the sensor's resistance. Pressing lightly, the resistance changes from...

This is a piezoresistive force sensor. The harder you press, the lower the sensor's resistance. Pressing hard, the resistance changes from infin...

VFD tube, vacuum fluorescent display, which was invented in Japan in 1967, typifies the display component of the vacuum electronic era. ...

A snap is fun, but a magnetic snap adds a whole new layer of possibilities. This are relatively large 18mm diameter snaps (all three pieces come as...

This is the Bare Conductive Pi Cap, a small, shield-like device that adds precise capacitive touch, distance sensing and high-quality audio to your...

This is a 600mm (23.62") servo extension cable. This comes in very handy when your servo is further away from the controller than the wire on th...

This MiniQ motor wheel set is especially designed for education and hobbies. It features a powerful metal gear motors which provide a speedy ro...

The Teensy is a breadboard-friendly development board with loads of features in a, well, teensy package. Each Teensy 3.5 comes pre-flashed with ...