Device Accessories

These Silicone Tubes are replacements for your fancy professional silicone-tipped solder sucker! You can just cut a new section off as necessary...

This product includes 3-pin 2.0mm(0.08") mating connector housing(10 units) and crimp pins (30 units). They work with wires ranging from 28...

If you want to connect multiple EL wires/strips/panels up to one inverter, these splitters are quite useful. There is one male connector (goes to ...

This is a high quality metal servo horn. It fits Hitec standard servos, DF series servos and the Uptech CDS 5500 Servo. SPECIFICATIONS ...

This is an inexpensive 3-foot-long HDMI to Mini HDMI cable that you can use to hook up your Raspberry Pi Zero W to a suitable monitor or TV. Heck, ...

There's two standard ways to power electronics - USB or 5.5mm/2.1mm DC barrel jack. This or that! With this USB to 2.1mm Male Barrel Jack Cable,...

This is a parts box for securely holding small electronic components in individual compartments. There are 10 removable dividers used to vary...

This is a 2-pin female housing pin with a pitch of 2.54mm(0.1"). You can make customized cables that mate with the 0.1"-spaced pins. NOTE...

These are 8mm (0.31") ball bearings. They will fit on 8mm (0.31") rods.​ SPECIFICATIONS Model:688zz Inner diameter:8mm (0....

This is a black braided cable guide. The braid provides some rigidity to the cables, also, it can be expanded by compressing it which will allo...

NFC Tag (13.56MHz) is widely used in electronic locks or customer identification as well as other systems where a small and easy to carry tag i...

If you need to connect an RJ45 cable (a.k.a Ethernet) to a board that with an Ethernet Jack - this adapter will come in very handy! No soldering...

A bunch of colorful nylon cable ties that help you bundle up things and make your project tidy. Comes in five vivid colors. They are: Fas...

Multiplexer has a set of interfaces for a variety of multi-function adapter plates. It supports USB, TTL, RS232, RS485 interfaces between the sy...

Yow! These things are super powerful. 1/2" diameter, 3/16" thick discs, south side is marked with a red line. Great for use with your SpokePOV Kit....

This spool of solid-core wire is easily soldered to and can handle up to 200°C and 600V. We like this wire because it's flexible but also holds ...

This here is your standard A-B USB cable, for USB 1.1 or 2.0. Perfect for connecting a PC to your Arduino, USBtinyISP (among other things).3 feet /...

Looking for the best heat sink for your Raspberry Pi 3? Check out this nice and tall 15x15x15mm Heat Sink! This heat sink is made from high q...

The TRS (tip ring sleeve) jack breakout is a simple board that allows a ¼" stereo audio jack to be soldered on to gain easy access to all of ...

Check out this handy USB extension cable, which will make it easy for you to enclose a device that has a Mini-B USB type port. We think this would ...

Standard Philips-head 4-40 screws. They are ¾" long and come in packs of ten. This is the screw size we use in most of the holes for our breakout b...

This is a simple three wire cable. Great for jumping from board to board or just about anything else. There is a 3-pin JST RE connector on both end...

Mighty needles, sew like the wind! This needle set is the only one you'll need for any sort of hand sewing, especially using our conductive thre...

Knobs are a great way to finish off your project and make it easier to adjust the level of your death ray. This knob mates to a 0.25" shaft. The kn...