Current & Voltage Sensors

SKU: EC-SEL71220A | Brand: Elecrow

A current sensing module based on the Allegro ACS712 Hall effect sensor, capable of accurately measuring both AC and DC current up to ±20 A. The module outputs a proportional analogue voltage that can be read directly...

SKU: AF-4226 | Brand: Adafruit

The Adafruit INA260 is a precision DC power sensor that measures current, voltage, and power on either the high or low side of your circuit. With an integrated 2 mΩ (0.002Ω) 0.1% shunt resistor and 16-bit ADC, it hand...

SKU: DF-SEN0211 | Brand: DFRobot

INTRODUCTION When you want to measure AC current it is impractical and hazardous to cut in to your live wiring. The analog AC current sensor developed by DFRobot is a good solution to this p...

SKU: DF-SEN0214 | Brand: DFRobot

The Gravity Analog 20A Current Sensor measures both AC and DC current using the Hall effect, outputting a proportional analog voltage to your microcontroller. With high-voltage isolation built into the circuit design ...

SKU: AF-6349 | Brand: Adafruit

The Adafruit INA238 is a precision DC power monitor capable of measuring current, voltage, and power on either the high or low side of your circuit. With support for up to +85V DC common-mode voltage and a 16-bit ADC,...

SKU: AF-6340 | Brand: Adafruit

The Adafruit INA237 is a precision DC power monitor capable of measuring current, voltage, and power on either the high or low side of your circuit. With support for up to +85V DC common-mode voltage and a 16-bit ADC,...

SKU: DF-SEN0288 | Brand: DFRobot

A non-contact AC current sensor with a clamp-on transformer probe, capable of measuring 0–10 A AC. Simply clamp the probe around an AC line and connect the 3.5 mm plug to the signal conversion module — no wire cutting...

SKU: DF-SEN0287 | Brand: DFRobot

When you want to measure the AC current, are you still having trouble cutting the wires, wiring or soldering. Gravity: Analog AC Current Sensor comes to the rescue, eliminating the need to cut wires or reconnect circu...

SKU: AF-3650 | Brand: Adafruit

The Adafruit INA219 FeatherWing is a high-side current and voltage sensor that stacks onto any Feather development board. Using the INA219B chip over I2C, it measures both DC current draw and bus voltage with 1% preci...

SKU: AF-5832 | Brand: Adafruit

This breakout brings the INA228 power monitoring chip out to an easy-to-use board for measuring DC current, bus voltage and calculated power on either the high side or the low side of a circuit. It combines a wide com...