Breakouts

This is the MS5803-14BA Pressure Sensor Breakout, a high resolution pressure sensor with both an I2C and SPI interface. This MEMS pressure sensor m...

INTRODUCTION This adapter is especially designed for DFRobot 12V DC Motors, adding the compatibility factor for those...

The Terminal Block Breakout FeatherWing kit is like the Golden Eagle of prototyping FeatherWings (eg. majestic, powerful, good-looking). To s...

The seven band graphic equalizer IC is a CMOS chip that divides the audio spectrum into seven bands. 63Hz, 160Hz, 400Hz, 1kHz, 2.5kHz, 6.25kHz and ...

This simple breakout board makes it easy to use our LED tactile switches in a breadboard, or your next project. Note: Populate the board accord...

The RN-52 Bluetooth from Roving Networks is an audio module that makes it simple for you to create a hands free audio system for your car or remote...

If you’ve had ideas for a project that depends on the ability to sense different spectrums of visible light and react based on those measurements, ...

INTRODUCTION This GPS Receiver is Discontinued Now, We recommend GPS Receiver for Arduino (Model A) as a suitable rep...

INTRODUCTION 3-Axis acceleration sensor is an electronic equipment which could measure the acceleration during the objec...

The ADXL377 is a small, thin, low power, complete 3-axis accelerometer with signal conditioned analog voltage outputs that has a full-scale range ...

We all know the BeagleBone Black is pretty great, but wouldn’t it be nice to create personal capes based on your needs? The SparkFun BeagleBone Bla...

We just love this little 1.8" TFT display, with true TFT color (up to 18-bits per pixel!), fine 160x128 resolution, two white LED backlight that...

This is a breakout board for the ultra low-power LIS331HH three axis linear accelerometer. The device has a digital I2C/SPI serial interface which ...

This breakout board makes it easy to use the tiny MMA8452Q accelerometer in your project. The MMA8452Q is a smart low-power, three-axis, capacit...

This is the SparkFun USB to Serial Breakout for the FT232RL, a small board with a built in USB to serial UART interface. This little breakout is bu...

Add motion, direction and orientation sensing to your Arduino project with this all-in-one 9-DOF sensor. Inside the chip are three sensors, one ...

This simple board breaks out a female USB type A connector’s VCC, GND, D- and D+ pins to a 0.1" pitch header. If you want to add a USB to  yo...

PowerBoost is the perfect power supply for your portable project! This little DC/DC boost converter module can run from 1.8V batteries or higher...

Freescale’s MAG3110 is a small, low-power, digital 3-axis magnetometer. The device can be used in conjunction with a 3-axis accelerometer to produc...

INTRODUCTION This Raspberry Pi prototyping shield is compatible with models B+, 2B and newest 3B. It stacks on top of...

It's summer and you're sweating and your hair's all frizzy and all you really want to know is why the weatherman said this morning that today's ...

This is a simple breakout for the ADXL345 accelerometer and the ITG-3200 MEMS gyro. With this board, you get a full 6 degrees of freedom. The senso...

INTRODUCTION The Cookie I/O expansion shield is designed for beginners to electronics. The shield is directly compatible...

This 1.27mm pitch, 2x5 male SMT Box Header is the same one used on our SWD Cable Breakout Board. The header alone is great if you want to inc...