All Products

The Arduino XBee shield is designed to meet wireless sensor networks such as wifi, bluetooth 2.0/4.0 and zigbee. The module is easy to use, low...

Add motion, direction and orientation sensing to your Arduino project with this all-in-one 9-DOF sensor. Inside the chip are three sensors, one is ...

 INTRODUCTIONThis DC Motor shield for Arduino uses L293 chip which allow to drive two 7-12V DC motors with maximum 1A current each channel. Thi...

This is a black insulated binding post. These binding posts do accept banana plugs, and are a great way to connect single-wire leads. The colore...

This is an omni-directional antenna with an IPEX connector. Its working frequency is 2.4GHz which meets most requirements of Wi-Fi devices. W...

These dual channel 45 degree angle brackets mate directly to Actobotics channels and hub mounts and are useful as attachment points. They sha...

The swivel hub lets you connect any two parts with the 0.77" hub pattern together and have them swivel a full 360 degrees. Internal ball bearing...

This is a crimp pin for the ZH-6 JST connector, which can be used to interface with the GP2Y1010AU0F Optical Dust Sensor. These are sold as i...

For many years, instructors and teachers have asked us to come up with a better way to teach programming and electronics. We have worked on Circ...

Unlike most of the other temperature sensors we have, this breakout has a really cool IR sensor from TI that can measure the temperature of an o...

Connect your own PCB to a Raspberry Pi B+ with this extra-tall female header. The female header part has extra spaces to make it 16.5mm tall: wh...

These white precision disk wheels have an outer diameter of 5”, a width of 0.23”, and utilize the 0.77” hub pattern. These simple wheels are ide...

Now mounted on a breakout board, the MPL115A1 is a digital barometer that uses MEMs technology to give accurate pressure measurements between 50kPa...

This 12-inch (30-cm) cable has 26 AWG wires and a 3-pin female JST PH-style connector that works with Sharp analog distance sensors that have matin...

These smooth (round) belts have a Durometer hardness of A70 and can withstand temperatures from -35 to 250 degrees F. Their elastic nature allow...

The FTDI cable is a USB to Serial (TTL level) converter which allows for a simple way to connect TTL interface devices to USB. The VCC pins of t...

Introducing the MENTA, a portable minty Arduino-compatible project that fits into a common mint tin. We took our super popular Boarduino seri...

The DFRobot CurieNano is a small development board based on the Intel Curie module. It is easy to use and perfectly compatible with the Genui...

These flat dual channel brackets mate directly to Actobotics channels and hub mounts and are useful as attachment points. They share the same 0....

The APC220 radio module provides a simple and economic solution to wireless data communications. Integrates an embedded high speed microproce...

Kelvin clips are used whenever you need to get a measurement right at the contact points of a circuit or component. Even though these are grippy cl...

This is the newest revision of our FTDI Basic. We now use a SMD 6-pin header on the bottom, which makes it smaller and more compact. Functionali...

By popular demand! We now have a way to attach a Raspberry Pi computer to a plastic 'dish' with a full-sized breadboard. We designed it carefull...