Adafruit
N-channel power MOSFET [30V / 60A]
·
When you need to switch a lot of power, N channel MOSFETs are best for the job. These FETs can switch over 60A and 30V and are TO-220 package so they fit ...
Get notified when back in stock
When you need to switch a lot of power, N channel MOSFETs are best for the job. These FETs can switch over 60A and 30V and are TO-220 package so they fit nicely into any breadboard or perfboard. Heat sinking is easy with TO-220's, but because of the very low Rds(on) of down to 0.009 ohms (depending on the Vgs - check the datasheet) you can get away with no heatsinking for pretty high loads! The threshhold voltage is also very low, less than 2.5V so you can control it directly from a microcontroller running on 2.8V, 3.3V or 5V logic.
The TO-220 package can dissipate up to 2 Watts without a heat sink (at room temperature). Because it has an Rds of as low as 9 milliohms, that means that you can switch at least 15 Amperes without a heat sink - more if you use PWM. For more detailed calculation, we suggest this site which has always worked nicely!
Find this product in
Related Tutorials
Free step-by-step guides
You might also like
Customers who bought this also bought
Breadboard-friendly SPDT Slide Switch
$2.15
RP2040-Zero, a Pico-like MCU Board Based on Raspberry Pi MCU RP2040, Mini ver.
$5.85
Adafruit Micro SD SPI or SDIO Card Breakout Board - 3V ONLY!
$7.30
Adafruit DS3502 I2C Digital 10K Potentiometer Breakout - STEMMA QT
$10.55
Pololu 3.3V, 300mA Step-Down Voltage Regulator D24V3F3
$15.05
Brass Liquid Solenoid Valve - 12V - 1/2 NPS
$50.15
Gravity: Analog Water Pressure Sensor
$31.40
1N4001 Diode - 10 pack
$3.25
Jargon buster
Plain-language definitions for the technical terms in the product description.
- microcontroller
- A microcontroller is a small computer on a single chip that runs a stored program and controls connected inputs and outputs such as buttons, sensors, displays and communication interfaces. In a device built around one, it is the part that executes the code and coordinates the device's behaviour.
- PWM
- Pulse Width Modulation is a way for a digital pin to simulate variable output power by switching on and off very quickly. It matters for controlling things like LED brightness, motor speed, or servo-style signals from a microcontroller pin.