DFRobot
Gravity: Multifunctional Environmental Sensor
This multifunctional environmental sensor comprises SHTC3 temperature & humidity sensor, BMP280 barometric pressure sensor, VEML7700 ambient light sensor, an...
Get notified when back in stock
Features
Applications
Specification
Documents
Shipping List
Find this product in
Brands
Supplier page — dfrobot.com
Supplier Description · 816.1 KB · Click any page to view full size
SEN0501 gravity multifunctional environmental sensor schematics 1.0
Schematic · 325.7 KB · Click any page to view full size
Resources & Downloads
Guides, code examples, and more
Related Tutorials
Free step-by-step guides
You might also like
Customers who bought this also bought
Adafruit BMP280 I2C or SPI Barometric Pressure Altitude Sensor
$21.45
Gravity: Arduino CO/Combustible Gas Sensor (MQ9)
$13.10
8 Push Buttons Module
$4.05
USB-A Female to Type-C Male Adapter
$10.00
FireBeetle Board ESP32-E (Arduino Compatible)
$17.38
Speaker for micro:bit
$23.80
Jumper Jerky Junior - Female to Female
$2.20
Jumper Jerky Junior - Male to Female
$2.20
Jargon buster
Plain-language definitions for the technical terms in the product description.
- Ambient light sensor
- A sensor that measures the general brightness of light falling on it, similar to how a device can adjust screen brightness automatically. It matters when you want a project to react to room lighting, daylight, shadows, or covered/uncovered conditions.
- breakout
- A breakout board carries a small or fine-pitched component and brings its connections out to standard, breadboard- and header-friendly pins. Describing a part as a breakout means it can be wired into a project without soldering directly to the component's tiny contacts.
- DC
- DC means direct current, where electricity flows in one constant direction, as supplied by batteries, USB ports and many plug-pack power supplies. When a product specifies DC, it runs from a DC supply rather than mains AC, so you need to provide the correct voltage and polarity.
- Gravity
- Gravity is DFRobot’s plug-in connector system for sensors, motors and modules, using standard cables to reduce loose jumper wiring. It matters because Gravity-compatible parts can connect directly to these ports, while non-Gravity parts may need adapters or manual wiring.
- I2C
- I2C is a two-wire communication bus used by many sensors and small modules. It matters because several I2C devices can share the same two wires, but each device needs a compatible address and your controller must support I2C.
- UART
- UART is a simple asynchronous serial interface that sends data over separate transmit and receive wires, usually labelled TX and RX, with both ends set to the same baud rate. It is a common way for microcontrollers and other serial devices to exchange data.
- wavelength
- The distance between repeating peaks of a wave, often used to describe the colour of light in nanometres. For visible lasers and LEDs, wavelength tells you the approximate colour, such as red, green or blue.