Adafruit
Adafruit SPI FLASH Breakout - W25Q64 - 64 MBit / 8 MByte
The Adafruit SPI FLASH Breakout features a W25Q64 chip providing 64 Mbit (8 MByte) of non-volatile flash storage over a standard SPI interface. It's ideal fo...
The Adafruit SPI FLASH Breakout features a W25Q64 chip providing 64 Mbit (8 MByte) of non-volatile flash storage over a standard SPI interface. It's ideal for adding compact, low-power external storage to microcontroller projects — perfect for files, images, fonts, and audio clips when a full SD card is more than you need.
Unlike QSPI breakouts, this board includes level shifting so it works safely with both 3.3V and 5V logic, plus a 3.3V regulator and a pull-up on chip select. The chip comes blank and can be addressed as flat memory or formatted with a filesystem like LittleFS or FAT.
Key Features
- W25Q64 Flash Chip – 64 Mbit (8 MByte) non-volatile SPI flash storage
- SPI Interface – Single-channel SPI with level shifting for 3V or 5V logic
- 3.3V Regulator – Onboard regulator and CS pull-up for clean operation
- Blank Chip – Address as flat memory or format with LittleFS/FAT
- Breadboard-Friendly – Includes header for breadboard use
Also Consider
- SPI FLASH Breakout W25Q128 – 128 Mbit / 16 MByte – Double the storage capacity
Ideal For
- Data logging and sensor storage
- Storing images, fonts, and audio clips
- Adding external memory to older 5V microcontrollers
- Projects that need more than EEPROM but less than an SD card
Package Contents
- 1× SPI FLASH breakout board (W25Q64)
- 1× Header strip
Resources
Jargon buster
Plain-language definitions for the technical terms used above.
- 3.3V regulator
- A 3.3V regulator is a power circuit that provides a steady 3.3 volts for parts that need that supply voltage. On a breakout board, it can let the sensor run safely even when the connected microcontroller or power source uses a higher voltage.
- breakout
- A breakout is a small circuit board that makes a tiny or hard-to-solder component easier to connect to with standard pins. It matters because this OLED module can be wired into a microcontroller project without needing to solder directly to the display’s fine contacts.
- CS
- CS stands for chip select, a control pin used by SPI devices to tell which connected device should listen. It matters when you connect more than one SPI module to the same microcontroller, because each device usually needs its own CS pin.
- EEPROM
- A type of non-volatile memory that keeps stored data even when power is turned off. In a sensor module, it can be used to store settings or calibration data so they do not need to be re-entered every time.
- microcontroller
- A microcontroller is a small computer on a chip that runs your program and controls connected inputs and outputs. For this product, it is the part that reads buttons and sensors, drives the display and speaker, and communicates over Bluetooth.
- SPI
- A fast serial communication bus often used for displays, memory cards, and sensors. It matters because SPI devices need specific pins for clock and data, plus a separate chip-select line for each device.
Find this product in
Brands
Prototyping & Wiring
