SparkFun

SKU: SF-CAB-15455 | Brand: SparkFun

This panel mount USB-C extension cable enables you to more easily enclose a project that contains a USB-C port. The cable is 6" in length and includes two 14mm M3 screws compatible with the cable's 3mm panel mount hol...

SKU: SF-SEN-14727 | Brand: SparkFun

This miniature straight bar load cell (sometimes called a strain gauge) can translate up to 100g of pressure (force) into an electrical signal. Each load cell is able to measure the electrical resistance that cha...

SKU: SF-WRL-14875 | Brand: SparkFun

A compact 1/4-wave rubber duck antenna for LoRa and other 860–960MHz communication. With a centre frequency of 915MHz and 2dBi gain, this 110mm antenna is ideal for space-constrained LoRa nodes where a smaller antenna...

SKU: SF-ROB-13302 | Brand: SparkFun

These are a pair of hobby gearmotors from DAGU. These gearmotors are the same ones recommended for use in the Shadow Chassis and offer a cheap and easy-to-use setup to get your wheels turning. Each Hobby Gearmotor als...

SKU: SF-DEV-11114 | Brand: SparkFun

It’s blue! It’s thin! It’s the Arduino Pro Mini! SparkFun’s minimal design approach to Arduino. This is a 3.3V Arduino running the 8MHz bootloader. Arduino Pro Mini does not come with connectors populated so tha...

SKU: SF-PRT-12978 | Brand: SparkFun

A pack of 10 multicoloured alligator-to-alligator clip test leads — an essential for any electronics workbench. Whether you're making quick connections to test a circuit or extending your multimeter leads, these sprin...

SKU: SF-COM-10632 | Brand: SparkFun

Check out these big 10mm through-hole LEDs! The opaque epoxy package causes these LEDs to have a soft, diffuse glow.

SKU: SF-SEN-10266 | Brand: SparkFun

Use this simple IR receiver for infrared remote control of your next project. With low power consumption and an easy to use package, it mates well with embedded electronics and can be used with common IR remotes. The...

SKU: SF-PRT-12615 | Brand: SparkFun

A standard full-size solderless breadboard with 830 tie points for prototyping electronic circuits. The two sets of five columns are separated by a 0.3″ channel — perfectly sized for straddling DIP IC packages. Split ...

SKU: SF-COM-09806 | Brand: SparkFun

There are lots of trimpots out there. Some are very large, some so small they require a screwdriver. Here at Little Bird, we just needed a simple one that worked. This 10K trimmable potentiometer has a small knob...

SKU: SF-DEV-09718 | Brand: SparkFun

The FTDI Cable is a USB-to-Serial (TTL level) converter that provides a simple way to connect TTL interface devices to USB. Built around the FTDI FT232RQ chip housed in the USB-A connector, this cable operates at 5V l...

SKU: SF-SEN-09375 | Brand: SparkFun

This is a force sensitive resistor with a round, 0.5" diameter, sensing area. This FSR will vary its resistance depending on how much pressure is being applied to the sensing area. The harder the force, the lower the ...

SKU: SF-TOL-17235 | Brand: SparkFun

The Stickvise holds your PCB flat at table level, giving your hands a stable surface to rest on while soldering — a significant advantage over elevated, tilted vises when working on fine pitch components. The low-prof...

SKU: SF-COM-16473 | Brand: SparkFun

The classic 555 timer/oscillator IC from Texas Instruments — one of the most versatile and widely used integrated circuits in electronics. With just a few external resistors and capacitors, it can generate timing dela...

SKU: SF-KIT-16274 | Brand: SparkFun

The SparkFun micro:climate kit is a full weather station kit that is built on top of the weather:bit carrier board. Unlike previous weather kits we've carried, this micro:climate kit is Qwiic enabled and includes o...

SKU: SF-DEV-15945 | Brand: SparkFun

The SparkFun Qwiic pHAT V2.0 for Raspberry Pi provides you with the quickest and easiest way to enter into SparkFun’s Qwiic ecosystem while still using that Raspberry Pi that you’ve come to know and love. The Qwiic...

SKU: SF-WRL-15126 | Brand: SparkFun

After years of popularity with the XBee Series 1 and XBee Series 2, we now have the XBee Series 3 which brings the best of both worlds. XBee 3 not only handles 802.15.4, and ZigBee, but also BLE protocols and you can ...

SKU: SF-DEV-15123 | Brand: SparkFun

The SparkFun RedBoard Qwiic is an Arduino-compatible development board in the UNO R3 form factor with a built-in Qwiic connector for solderless I2C hookup. It programs over USB Micro-B using the Arduino IDE — select "...

SKU: SF-COM-15105 | Brand: SparkFun

This diode-transistor photocouplers consist of an LED, optically coupled to a high speed photodetector to transmit electrical signals between circuits while still isolating your system from higher voltages. The 6N137 ...

SKU: SF-COM-14978 | Brand: SparkFun

This little round on/off/on toggle switch is rated up to 10A at 125VAC and can be panel mounted in a 20mm diameter hole. It’ll also look pretty slick in your project!