Sensors

Breakout board for the low power, single axis ADXL193 MEMS accelerometer. The ADXL193 is a high-g sensor with a full scale range of ±250g! The ADXL...

This rubber ring is used to afix ultrasonic sensor. It fits URM37 V4.0 Ultrasonic Sensor For Arduino / Raspberry Pi and URM04 Ultrasonic Sens...

Control the same hardware as used in space...build your very own Astro Pi with the new Raspberry Pi Sense HAT! The Raspberry Pi Sense HAT is att...

This S-Type load cell (sometimes called a strain gauge) can translate up to 200kg of pressure (force) into an electrical signal. Each load cell is ...

This is a tiny trackball akin to those found on a number of Blackberry models (8100, 8300, 8320, 8800, 8830, etc). Each of the four spindles hav...

EcoDuino is evolving. Now the EcoDuino has an enclosure. It is protected from water splashes, so it is safe to use beside your plants. The Eco...

This Gyro Breakout Board is Discontinued Now, We recommend more IMU Sensors as a suitable replacement. The ADXRS MEMs gyroscope from Ana...

The Qwiic Micro OLED is a small monochrome, blue-on-black OLED. It’s “micro”, but it still packs a punch – the OLED display is crisp, and you ca...

The VCNL4010 sensor is a nice way to add a small-distance proximity sensor to your microcontroller project. For longer distances (in the range o...

It’s beautiful here in Boulder, Colorado, but any newcomer to the area quickly discovers our wonderful 300 days of sunshine is tempered with the...

The ADXL335 is a small, thin, low power, complete 3-axis MEMS accelerometer with signal conditioned voltage outputs. The product measures accelerat...

The Qwiic NIR Spectral Sensor uses the AS7263 near infrared spectrometer from AMS for spectral identification. What can you do with NIR spect...

The Minisense 100 from Measurement Specialties is a low-cost cantilever-type vibration sensor loaded by a mass to offer high sensitivity at low fre...

The Minisense 100 from Measurement Specialties is a low-cost cantilever-type vibration sensor loaded by a mass to offer high sensitivity at low fre...

The Qwiic Accelerometer makes it extremely easy to get playing with tilt, acceleration, and movement sensing. Plug a Qwiic Shield onto your plat...

There are already many I2C devices in the wild. The Qwiic adapter converts the standard I2C pinout (GND, 3.3V, SDA, and SCL) to the 4-pin 1mm JS...

This basic piezo sensor from Measurement Specialties is often used for flex, touch, vibration and shock measurements. A small AC and large voltage ...

INTRODUCTION This is an Arduino Propane Gas Sensor. It uses MQ6 probe to detect iso-butane, propane and liquefied pe...

INTRODUCTION This is an Arduino Carbon Monoxide Sensor. It uses MQ7 probe to detect Carbon Monoxide (CO) concentrati...

This is an Arduino LPG gas sensor. It has MQ5 probe which is very sensitive with LPG, natural gas , town gas. It is less sensitive with alcoh...

This semiconductor gas sensor detects the presence of Carbon Monoxide at concentrations from 10 to 1,000 ppm and combustible gas from 100 to 10,000...

The Electron is a tiny development kit for creating 3G cellular-connected electronics projects and products. It comes with a Particle SIM car...

This non-contact liquid level switch can be triggered when the liquid level fall below the sensor attached to the outside surface of a non-metal...

The Type 5 Pocket Geiger Radiation Sensor from Radiation Watch is a highly sensitive radiation sensor designed for the embedded systems market. Cap...