Sensors & Modules

SKU: SF-SEN-13285 | Brand: SparkFun

This is a simple to use motion sensor. Power it up and wait 1-2 seconds for the sensor to get a snapshot of the still room. If anything moves after that period, the ‘alarm’ pin will go low.This unit works great from 5...

SKU: AF-334 | Brand: Adafruit

If you've got a resistive touch screen that you'd like to use, you'll need this breakout! It has a fine pitch (0.5mm) connector soldered onto it and it's broken out into the 4 resistive wires of the panel. A petite...

SKU: SF-SEN-13266 | Brand: SparkFun

The SparkFun MAX31855K Thermocouple Breakout is a simple 14-bit resolution, SPI-compatible, serial interface thermocouple digitizer that makes reading a wide range of temperatures possible. A thermocouple works by ...

SKU: SF-SEN-11084 | Brand: SparkFun

Life has its ups and downs, so why not measure them? The MPL3115A2 is a MEMS pressure sensor that provides Altitude data to within 30cm (with oversampling enabled). The sensor outputs are digitized by a high reso...

SKU: AF-374 | Brand: Adafruit

These 1-wire digital temperature sensors are fairly precise (±0.5°C over much of the range) and can give up to 12 bits of precision from the onboard digital-to-analog converter. They work great with any microcontro...

SKU: SF-SEN-11005 | Brand: SparkFun

This non-invasive current sensor (also known as a split-core current transformer) clamps around the supply line of an electrical load to measure how much current is flowing through it. The sensor acts as an inductor, ...

SKU: AF-444 | Brand: Adafruit

Add a tiny joystick to your project with this PSP thumbstick. This is a replacement component for PSP1000's, but we think they'd make for a great little joystick/thumbstick add-on for a wearable, or portable pro...

SKU: DF-FIT0454 | Brand: DFRobot

This is a small built-in spring GSM antenna with IPX connector. Its working frequency is 900/1800 MHz which meets most requirements of GSM applications. Its very compact size makes it easy to carry and use. ...

SKU: SF-BOB-10160 | Brand: SparkFun

Here is a real time clock based on the DS3234 Real Time Clock IC. The DS3234 is a low-cost, extremely accurate SPI bus real-time clock with an integrated temperature-compensated crystal oscillator and crystal. Th...

SKU: AF-1918 | Brand: Adafruit

An analog UV light sensor breakout based on the GUVA-S12SD photodiode, detecting the 240–370nm range covering UVB and most of the UVA spectrum. An on-board op-amp amplifies the tiny photodiode current to a readable vo...

SKU: DF-SEN0018 | Brand: DFRobot

This is a simple to use arduino motion sensor. Power it up and wait 1-2 seconds for the sensor to get a snapshot of the still room. If anything moves after that period, the 'alarm' pin will go low. This sensor c...

SKU: DF-SEN0220 | Brand: DFRobot

The Gravity UART Infrared CO2 Sensor uses non-dispersive infrared (NDIR) technology to measure carbon dioxide concentrations from 0 to 50,000 ppm. It offers excellent selectivity with no oxygen dependency, built-in te...

SKU: DF-DFR0053 | Brand: DFRobot

This arduino Slide Position Sensor is based on straight-slip slide potentiometer sensor. The sensor is able to give provide the position of the slider which is often considered as a linear potentiometer . The ...

SKU: SF-ROB-09454 | Brand: SparkFun

The SparkFun QRE1113 Line Sensor Breakout (Digital) is a compact IR reflectance sensor board that outputs a digital signal based on surface reflectivity. It uses a capacitor discharge circuit — the faster the 10 nF ca...

SKU: SF-SEN-09417 | Brand: SparkFun

This is a simple, thumbnail-size RFID tag. These tags are great for sensing presence, identification, etc., and they’re small, so they can be easily sewn into clothing or inserted into enclosures. Each tag comes with ...

SKU: SF-SEN-09405 | Brand: SparkFun

A simple-to-use MQ-6 gas sensor for detecting liquefied petroleum gas (LPG) — primarily propane and butane — in the air. The sensor detects concentrations from 200 to 10,000 ppm with high sensitivity and fast response...

SKU: SF-SEN-09404 | Brand: SparkFun

This is a simple-to-use compressed natural gas (CNG) sensor, suitable for sensing natural gas (composed of mostly Methane [CH4]) concentrations in the air. The MQ-4 can detect natural gas concentrations anywhere from ...

SKU: AF-333 | Brand: Adafruit

A 4-wire resistive touch screen digitiser (originally designed for the Nintendo DS Lite) that works with a stylus or fingertip. It can be used with any microcontroller that has 2 digital pins and 2 analogue input pins...

SKU: YH-3000101267 | Brand: Yahboom

Yahboom K230 vision module is a high-performance, low-power embedded AI vision processing module designed for edge computing scenarios. It is designed based on the end-side AloT chip of the RISC-V architecture, with 6...

SKU: LB-LS6779 | Brand: Little Bird

This Remote takes 2 x AAA batteries making it safe to use in schoolsIt has 12 buttons that can be pressed and will send an IR signalThis remote is now included with many of our kits and sends the following signalsOn&n...