Sensors & Input

SKU: DF-DFR0198 | Brand: DFRobot

This is a waterproofed version of the DS18B20 Temperature sensor. Handy for when you need to measure something far away, or in wet conditions. While the sensor is good up to 125°C the cable is jacketed in PV...

SKU: SF-SEN-13879 | Brand: SparkFun

The SparkFun Load Cell Amplifier is a small breakout board for the HX711 IC that allows you to easily read load cells to measure weight. By connecting the amplifier to your microcontroller you will be able to read the...

SKU: LB-LR0007 | Brand: Little Bird

Flame Detection Sensor Module for use with Arduino Sensor for flame wavelengths between 760 nm to 1100 nm infrared is most sensitive60 degree detection sensor   Two outputs mode: AO: analog output, real-time ou...

SKU: LB-LS4690 | Brand: Little Bird

Digital temperature sensor DS18B20, waterproof case. Working range from -55 to 125 degrees. Resolution 0.5 in range from -10 up to 85 degrees.

SKU: SF-SEN-11050 | Brand: SparkFun

This sealed digital temperature probe lets you precisely measure temperatures in wet environments with a simple 1-Wire interface. The DS18B20 provides 9 to 12-bit (configurable) temperature readings over a 1-Wire i...

SKU: SF-BOB-12009 | Brand: SparkFun

The SparkFun Bi-Directional Logic Level Converter safely translates signals between different voltage levels — stepping 5V down to 3.3V and 3.3V up to 5V on the same channel. It also works with 2.8V and 1.8V devices, ...

SKU: DF-KIT0021 | Brand: DFRobot

A waterproof DS18B20 digital temperature sensor kit with everything you need to connect to an Arduino. The stainless steel probe measures temperatures from -55°C to +125°C over a 1-Wire interface, requiring just one d...

SKU: DF-SEN0189 | Brand: DFRobot

The Gravity Analog Turbidity Sensor measures water clarity by detecting the level of suspended particles. It works by measuring light transmittance and scattering rate, which change with the amount of total suspended ...

SKU: SF-COM-09117 | Brand: SparkFun

This is a 12-step rotary encoder with a nice ‘clicking’ feel. It’s breadboard friendly, and has a pretty handy select switch (by pushing in on the knob). The encoder is different from a potentiometer in that an enc...

SKU: AF-5715 | Brand: Adafruit

The ESP32-H2-DevKitM-1 is an entry-level development board based on the ESP32-H2-MINI-1 module, featuring Bluetooth Low Energy 5, IEEE 802.15.4, Thread, Matter, and Zigbee support on a single chip. It's an ultra-low-p...

SKU: DF-DFR0896 | Brand: DFRobot

The ESP32-S3-WROOM-1-N4 is a powerful Wi-Fi and Bluetooth LE MCU module built around the ESP32-S3 SoC. Featuring a dual-core Xtensa LX7 processor running at up to 240MHz, 4MB SPI flash, and hardware acceleration for n...

SKU: SF-SEN-18367 | Brand: SparkFun

A sealed, waterproof DS18B20 digital temperature probe for precise measurements in wet or harsh environments. The sensor communicates over a 1-Wire interface, requiring just one data pin (plus ground) to connect to yo...

SKU: DF-SEN0448 | Brand: DFRobot

A 4-wire slot-type photoelectric switch with integrated optical transmitter and receiver. The 5mm detection slot can detect objects passing through, including transparent materials, making it ideal for counting, posit...

SKU: AF-3985 | Brand: Adafruit

This T-Slot Photo Interrupter with Cable is a simple plastic sensor with two elements - an IR LED and an IR photo-transistor, situated across a U-shaped gap. You can control the IR LED and turn it on to transmit IR...

SKU: AF-1375 | Brand: Adafruit

This breakout board is the simplest way to create a project with a single "toggle" capacitive touch sensor. No microcontroller is required here - just power with 1.8 to 5.5VDC and touch the pad to activate the sens...

SKU: DF-DFR0028 | Brand: DFRobot

This is an arduino tilt sensor. It is used to detect orientation. Inside the sensor, there is a ball that make contact with the pins when the case is upright. Tilt the sensor over and the balls don't touch, thus n...

SKU: DF-SEN0523 | Brand: DFRobot

This IR break-beam photoelectric switch detects objects by sending an invisible infrared beam from an emitter to a receiver. When a non-transparent object passes between the two and breaks the beam, the receiver outpu...

SKU: EC-DPI32110W | Brand: Elecrow

ESP32-S2-WROVER and ESP32-S2-WROVER-I use ESP32-S2 chip. The ESP32-S2 chip is equipped with an Xtensa® 32-bit LX7 single-core processor with a working frequency of up to 240 MHz. The user can turn off the power of the...

SKU: SF-BOB-13906 | Brand: SparkFun

The SparkFun Multiplexer Breakout provides access to all pins and features of the 74HC4051, an 8-channel analog multiplexer/demultiplexer. The 74HC4051 allows you to turn four I/O pins into eight multifunctional, indi...

SKU: DF-SEN0216 | Brand: DFRobot

The Water Flow sensor measures the rate of a liquid flowing through it. The YF-S401 water flow sensor consists of a plastic valve body, flow rotor and hall effect sensor. It is usually used at the inlet end to det...