Actuators

SKU: SF-COM-10924 | Brand: SparkFun

These are massive single pole - double throw (SPDT) sealed relays. This means that when current is applied to the coil it throws a simple changeover switch, terminating the connection from the NC contact to ground and...

SKU: SF-ROB-10848 | Brand: SparkFun

These steppers have a threaded shaft, which allows them to be used as a linear actuator. As the motor runs, it moves along the shaft at a specific rate of 1cm per 5 full rotations. These are a good choice for linear m...

SKU: DF-FIT0419 | Brand: DFRobot

INTRODUCTION This is a new micro DC geared motor, using planetary gear mechanism, applicable to the various types of DIY project. Especially the project which has a certain requirements for ...

SKU: DF-FIT0457 | Brand: DFRobot

INTRODUCTION This motor has a long (0.365"/9.27 mm) D profile metal output shaft that matches the 42x19mm and 32x7mm dimensions of the Pololu wheel. The brass faceplate has two mounting h...

SKU: DF-FIT0468 | Brand: DFRobot

This compact micro metal gear motor features a 50:1 gear ratio and a D-profile metal output shaft, making it ideal for small robotics platforms and wheeled projects. The shaft dimensions are compatible with Pololu 42×...

SKU: SF-ROB-10189 | Brand: SparkFun

Here, for all your mechatronic needs, is a simple, high quality continuous rotation servo motor. This servo is able to take in 6 volts and deliver 30.6 oz-in. of maximum torque at 0.14 sec/60° A standard 3-pin power...

SKU: DF-FIT0495-E | Brand: DFRobot

This compact metal DC geared motor features a 99:1 metal gear reduction for high torque output in a small form factor. With a maximum torque of 2.5kg·cm, it's built for robotics, automation, and mechanical projects re...

SKU: DF-FIT0045 | Brand: DFRobot

A pan-and-tilt servo assembly for horizontal surface mounting, built with two DFRobot DF05BB ball-bearing servos and aluminium brackets. Ideal for camera gimbals, sensor heads, and small remote-controlled robot platfo...

SKU: LB-LS7942 | Brand: Little Bird

Robot Arm Vacuum Pump & Valve Kit – PWM Electronic Switch Controller with Suction Cup (Arduino Compatible)Take your robotics projects to the next level with this compact vacuum suction kit, designed for robotic arms, ...

SKU: DF-DFR1224 | Brand: DFRobot

Restore a Maqueen V5 STEM robot after a damaged or jammed drive motor with this official replacement N20 motor accessory kit. It is intended as a repair part for an existing Maqueen V5, rather than an add-on needed wh...

SKU: DF-DFR1225 | Brand: DFRobot

Repair a damaged Maqueen Plus V3 motor without replacing the whole robot. This official DFRobot N20 motor accessory kit is made for quick classroom or project repairs when dust, hair, particles or rough handling have ...

SKU: DF-DRI0056 | Brand: DFRobot

This Gravity haptic driver module is built for Linear Resonant Actuators (LRAs), turning simple I2C commands into crisp tactile feedback for interactive projects. It is powered by the TM6605 driver chip and supports L...

SKU: DF-DRI0058 | Brand: DFRobot

This compact DFRobot driver board is made for precise control of brushless DC motors using Field-Oriented Control (FOC). At just 26 x 21.5mm, it is well suited to tight builds where smooth motion, low noise and respon...

SKU: DF-SER0057 | Brand: DFRobot

This clutch servo is designed for robots, models and other mechanisms where the servo may be pushed, stalled or forced out of position during use. Its clutch function helps protect the servo by allowing it to reset an...

SKU: SF-KIT-30715 | Brand: SparkFun

Add another controlled planting area to an existing AgXRP Starter Kit with this DIY expansion pack. It is designed to create a completely independent watering zone, so students can compare plant types, watering schedu...

SKU: ED-6968285823022 | Brand: Ed-Techs

This DC motor is designed for use with air:bit projects, giving you a compact motor option for builds that need powered rotation.It uses neodymium magnets and the cable colour identifies the rotation direction: red/bl...

SKU: DF-FIT1034 | Brand: DFRobot

This compact three-phase brushless DC motor is built for advanced motion control projects where smooth torque, low noise and precise feedback matter. It runs at a rated 12V and combines a 2804 BLDC motor with a built-...

SKU: DF-FIT1035 | Brand: DFRobot

This compact 2208 three-phase brushless DC motor combines a 12V BLDC motor with an integrated AS5600 magnetic encoder, making it a practical choice for closed-loop motor control and FOC experiments. It provides 300g.c...

SKU: DF-FIT1036 | Brand: DFRobot

This compact 4015 BLDC motor combines a high-torque outer rotor motor with a factory-integrated AS5600 magnetic encoder, making it a neat motion-control package for robotics and precision motion projects.It is designe...

SKU: DF-FIT1042 | Brand: DFRobot

The M0601 is a compact direct-drive hub motor for intelligent robots, AGVs, AMRs and other mobile platforms. It combines a brushless DC motor, servo driver and high-precision encoder into a 102mm diameter unit, reduci...