Elecrow
W5100 Ethernet Module
W5100 is a multifunctional Monolithic network interface chip, internal integrate a 10/100 Ethernet controller , it apply to a embedded system which is High-I...
W5100 is a multifunctional Monolithic network interface chip, internal integrate a 10/100 Ethernet controller , it apply to a embedded system which is High-Integrate, high-stability, high-performance but low-cost. By using it, we can complete the internet linking without operating system supporting. W5100 compatible with IEEE802.3 10BASE-T and 802.3u100BASE-TX. W5100 internal integrate TCP/IP,MAC,PHY with full hardware control. We just need to have some simple socket programming rather than considering the control of the Ethernet when we use the W5100.
Features
- Support Hardwired TCP/IP Protocols : TCP, UDP, ICMP, IPv4 ARP, IGMP, PPPoE, Ethernet
- 10BaseT/100BaseTX Ethernet PHY embedded
- Support Auto Negotiation (Full-duplex and half duplex)
- Support Auto MDI/MDIX
- Support ADSL connection (with support PPPoE Protocol with PAP/CHAP Authentication mode)
- Supports 4 independent sockets simultaneously
- Not support IP Fragmentation
- Internal 16Kbytes Memory for Tx/Rx Buffers
- 0.18 µm CMOS technology
- 3.3V operation with 5V I/O signal tolerance
- Small 80 Pin LQFP Package
- Multi-function LED outputs (TX, RX, Full/Half duplex, Collision, Link, Speed)
- Support Serial Peripheral Interface(SPI MODE 0, 3)
Jargon buster
Plain-language definitions for the technical terms used above.
- full-duplex
- Full-duplex means data can be sent and received at the same time. It matters for interactive serial links where commands and responses may need to travel in both directions without taking turns.
- LED
- A light-emitting diode is a small electronic component that lights up when current flows through it in the correct direction. In this kit, LEDs create the flashing effect, so polarity and correct soldering matter for the project to work.
- SPI
- A fast serial communication bus often used for displays, memory cards, and sensors. It matters because SPI devices need specific pins for clock and data, plus a separate chip-select line for each device.
- Tolerance
- Tolerance tells you how far the real resistance value may be from the printed value. A 1% resistor is useful when a circuit needs more predictable behaviour than a looser 5% or 10% part.
Find this product in
Brands
Related Tutorials
Free guides on learn.littlebird.com.au
