Seeed Studio
Grove - Mini Fan v1.1
All Products
New Arrivals
Robotics
Actuators
Brands and Manufacturers
Robotics & Motion
Motors (DC, stepper, servo)
Motor Drivers and Controllers
Grove
SeeedStudio
$19.00
|
Out of stock
Features Easy to use Cartoon Style mini fan Soft fan-blade to avoid injuries Built-in programmable microcontroller that uses Arduino IDE You can change the...
Estimated Delivery
Arrives
Disclaimer
Secure checkout
Features
- Easy to use
- Cartoon Style mini fan
- Soft fan-blade to avoid injuries
- Built-in programmable microcontroller that uses Arduino IDE
- You can change the code to drive servo motors instead of DC motor
Description
Hey hey, calm down, have some fresh air here. The Grove – Mini Fan v1.1 can be set up in seconds and bring you some nice and cool air in the hot days. It has four parts, a mini fan, a DC Motor, a DC motor driver and a Grove cable. The cartoon-style fan design makes it a good choice for decorating your little LEGO house as well.
The motor driver boards have a built-in programmable microcontroller that uses Arduino IDE. In default, it is programmed to drive DC motors with analogue inputs, and the rotate speed depends on the value of the input signal. You can simply connect up all the parts and plug it into a controller board that has Grove interfaces, upload some code and you are ready to make it spin.
Specification
- Input Voltage: 5V
- Connector: 4 Pin Buckled Grove interface for input signal; JST 2.0 interface for the DC motor
- Dimension: 20mm x 20mm
Documents
For all Grove users (especially beginners), we provide you with guidance PDF documents. Please download and read through Preface - Getting Started and Introduction to Grove before your using of the product.
Jargon buster
Plain-language definitions for the technical terms used above.
- Grove
- Grove is a plug-in connector ecosystem for sensors and modules that avoids soldering and jumper wires. Grove compatibility matters because it can make it quicker to add supported I2C devices, as long as the cable and voltage are suitable.
- IDE
- Short for Integrated Development Environment, a program used to write, run and manage code. It matters because some learners prefer a traditional coding workspace instead of a guided notebook-style lesson.
- microcontroller
- A microcontroller is a small computer on a chip that runs your program and controls connected inputs and outputs. For this product, it is the part that reads buttons and sensors, drives the display and speaker, and communicates over Bluetooth.
- motor driver
- An electronic circuit that lets a low-power controller switch and control a motor that needs more current than the controller pins can safely provide. Checking motor driver support matters because pumps and motors usually cannot be connected directly to a microcontroller output.
- servo
- A servo is a motor with built-in position control, usually told to move to a specific angle by a control signal. It matters when you need repeatable movement, such as steering, arms, flaps, or linkages, rather than continuous spinning.
Find this product in
Robotics & Motion
Related Tutorials
Free guides on learn.littlebird.com.au
