DFRobot
DC-DC Buck Converter 7-24V to 5V 4A
INTRODUCTIONThis is a 20W DC-DC buck converter power module with 7~24V input and 5V/4A output(Max). The high conversion efficiency and on-board 6 output port...
Get notified when back in stock
INTRODUCTION
This is a 20W DC-DC buck converter power module with 7~24V input and 5V/4A output(Max). The high conversion efficiency and on-board 6 output ports make it suitable for connecting multiple devices like, large current servos, programmable LED strip, etc.
The module integrates durable ceramic chip capacitors of large capacity on the ports and large inductor that can reduce heat generation. It is ideal for power supply scenarios like mechanical arm, servo robot, and programmable RGB LED strip, etc.
SPECIFICATION
- Input Voltage Range: 7-24V
- Output Voltage: 5V
- Output Current: 0-4A (Max 5A, heat dissipation is necessary)
- Conversion Efficiency: 90%
SHIPPING LIST
- DC-DC Buck Converter 7-24V to 5V/4A x1
Find this product in
Power & Batteries
You might also like
Customers who bought this also bought
Gravity: Throw-in Type Liquid Level Transmitter
$82.30
Raspberry Pi Zero 2 WH - with soldered headers
$34.85
SX1262 LoRa Node Module for Raspberry Pi Pico, LoRaWAN, 915Mhz
$22.60
A02YYUW Waterproof Ultrasonic Sensor
$32.78
Teensy 4.0
$36.05
Adafruit DS3502 I2C Digital 10K Potentiometer Breakout - STEMMA QT
$10.55
High Quality Gold Plated XT30 Male Female Bullet Connector
$3.35
Nano Expansion Prototype Shield v3.0
$8.75
Jargon buster
Plain-language definitions for the technical terms in the product description.
- Buck converter
- A power circuit that reduces a higher DC voltage to a lower DC voltage. It is useful when your supply voltage is too high for a module or microcontroller and you want less heat and better efficiency than a simple linear regulator.
- DC
- DC means direct current, where electricity flows in one constant direction, as supplied by batteries, USB ports and many plug-pack power supplies. When a product specifies DC, it runs from a DC supply rather than mains AC, so you need to provide the correct voltage and polarity.
- LED
- A light-emitting diode (LED) is a small electronic component that emits light when current flows through it in the correct direction. Because it only conducts one way, its polarity matters, and a through-hole LED must be soldered the correct way around to light up.
- RGB
- Short for red, green and blue, the three primary colours of light that are mixed in varying amounts to make a wide range of colours. In electronics RGB can refer to an LED or pixel that blends these three colours, or to a colour signal or interface that carries separate red, green and blue channels.
- servo
- A servo is a motor with built-in position control, usually told to move to a specific angle by a control signal. It matters when you need repeatable movement, such as steering, arms, flaps, or linkages, rather than continuous spinning.