Adafruit
Adafruit MS8607 Pressure Humidity Temperature PHT Sensor - STEMMA QT / Qwiic
The Adafruit MS8607 is a factory-calibrated 3-in-1 sensor that measures barometric pressure, relative humidity, and temperature over I2C. Made by TE Connecti...
The Adafruit MS8607 is a factory-calibrated 3-in-1 sensor that measures barometric pressure, relative humidity, and temperature over I2C. Made by TE Connectivity, this PHT (Pressure, Humidity, Temperature) sensor is a compact, all-in-one solution for weather stations, environmental monitoring, and climate-controlled enclosures.
With extremely low power consumption (as low as 0.78 µA), the MS8607 is well-suited for battery-powered sensing projects. The breakout includes a 3.3 V regulator and level shifting for compatibility with both 3.3 V and 5 V systems, plus STEMMA QT / Qwiic connectors for solderless I2C wiring.
Key Features
- Barometric Pressure – ±2 hPa accuracy
- Relative Humidity – ±3% RH accuracy
- Temperature – ±1°C accuracy
- 16-Bit Output – Factory-calibrated with constants stored on-chip
- Ultra-Low Power – As low as 0.78 µA for battery-friendly operation
- I2C Interface – Simple two-wire digital communication
- STEMMA QT / Qwiic Connectors – Solderless I2C connection (cable not included)
- 3.3 V and 5 V Compatible – On-board regulator and level shifting
Ideal For
- Weather stations and environmental monitoring
- Climate-controlled enclosures and terrariums
- Indoor air quality projects
- Battery-powered remote sensing
Package Contents
- 1× Adafruit MS8607 PHT Sensor Breakout (assembled)
- 1× Header strip
Resources
Jargon buster
Plain-language definitions for the technical terms used above.
- breakout
- A breakout is a small circuit board that makes a tiny or hard-to-solder component easier to connect to with standard pins. It matters because this OLED module can be wired into a microcontroller project without needing to solder directly to the display’s fine contacts.
- I2C
- I2C is a two-wire communication bus used by many sensors and small modules. It matters because several I2C devices can share the same two wires, but each device needs a compatible address and your controller must support I2C.
- Qwiic
- Qwiic is a plug-in connector system for I2C devices that uses small 4-pin cables, so you can connect compatible sensors without soldering. It matters because your controller or adapter also needs Qwiic, or you will need a cable or breakout to wire it up.
- STEMMA
- A plug-and-cable connection system used on some maker electronics boards to make wiring simpler. If a product uses STEMMA, you need the matching cable or connector type to plug it in without soldering.
- STEMMA QT
- A small plug-in connector system for I2C boards that lets you connect compatible sensors and controllers without soldering. It matters because it can make wiring faster and less error-prone, especially when adding several small modules to a project.
Find this product in
Brands
Related Tutorials
Free guides on learn.littlebird.com.au
