Adafruit MCP4728 Quad DAC with EEPROM - STEMMA QT / Qwiic

Jargon buster

Plain-language definitions for the technical terms used above.

breakout

A breakout board carries a small or fine-pitched component and brings its connections out to standard, breadboard- and header-friendly pins. Describing a part as a breakout means it can be wired into a project without soldering directly to the component's tiny contacts.

DAC

A digital-to-analogue converter turns numbers from the microcontroller into a real analogue voltage. It matters if you want to generate simple waveforms, audio-style signals, or variable control voltages rather than just on/off outputs.

EEPROM

A type of non-volatile memory that keeps stored data even when power is turned off. In a sensor module, it can be used to store settings or calibration data so they do not need to be re-entered every time.

Grove

Grove is a standardised 4-pin plug-in connector system for sensors and modules that avoids soldering and jumper wires, with different cable types carrying I2C, UART, analogue or digital signals. When a product is Grove-compatible it can be quicker to connect supported modules, provided the connector type, signal and voltage all match.

I2C

I2C is a two-wire communication bus used by many sensors and small modules. It matters because several I2C devices can share the same two wires, but each device needs a compatible address and your controller must support I2C.

Internal reference

An internal reference is a stable voltage source built into a converter chip that it uses as the fixed point for translating between digital values and voltages. When a DAC or ADC includes one you usually do not need to add a separate precision reference part, though an external reference can sometimes give better accuracy or a different range.

Qwiic

Qwiic is a plug-in connector system for I2C devices that uses small 4-pin cables, so you can connect compatible sensors without soldering. It matters because your controller or adapter also needs Qwiic, or you will need a cable or breakout to wire it up.

servo

A servo is a motor with built-in position control, usually told to move to a specific angle by a control signal. It matters when you need repeatable movement, such as steering, arms, flaps, or linkages, rather than continuous spinning.

STEMMA

A plug-and-cable connection system used on some maker electronics boards to make wiring simpler. If a product uses STEMMA, you need the matching cable or connector type to plug it in without soldering.

STEMMA QT

A small plug-in connector system for I2C boards that lets you connect compatible sensors and controllers without soldering. It matters because it can make wiring faster and less error-prone, especially when adding several small modules to a project.

VCC

VCC is the positive power-supply connection on a chip or module. Connecting it to the correct supply voltage is needed for the part to power on and helps avoid damaging the electronics.

voltage reference

A voltage reference is a stable, accurate voltage that a converter uses as its comparison point: an ADC measures its inputs relative to it, while a DAC scales its output to it. A more stable reference gives more consistent results, which matters most in precision sensing and instrumentation.