Sensors

SKU: SF-BOB-10160 | Brand: SparkFun

Here is a real time clock based on the DS3234 Real Time Clock IC. The DS3234 is a low-cost, extremely accurate SPI bus real-time clock with an integrated temperature-compensated crystal oscillator and crystal. Th...

SKU: AF-1918 | Brand: Adafruit

An analog UV light sensor breakout based on the GUVA-S12SD photodiode, detecting the 240–370nm range covering UVB and most of the UVA spectrum. An on-board op-amp amplifies the tiny photodiode current to a readable vo...

SKU: DF-SEN0207 | Brand: DFRobot

INTRODUCTION Most ultrasonic distance sensors aren't waterproof which can be a problem if you need your project to withstand the elements outdoors. No need to worry any more! We have develop...

SKU: SF-SEN-09674 | Brand: SparkFun

This very long force sensitive resistor - over 2 feet - has a sensing area of 0.25x24". This FSR from Interlink Electronics will vary its resistance depending on how much pressure is being applied to the sensing area....

SKU: DF-SEN0203 | Brand: DFRobot

The DFRobot heart rate sensor is a thumb-sized heart rate monitor designed for Arduino microcontrollers. This sensor is a pulse sensor which is developed based on PPG (PhotoPlethysmoGraphy) techniques. This ...

SKU: DF-DFR0030 | Brand: DFRobot

A digital capacitive touch sensor from DFRobot's Gravity series. It detects touch through the same capacitive sensing technology used in smartphones — even through thin cloth or paper. The sensor outputs a digital hig...

SKU: DF-SEN0018 | Brand: DFRobot

This is a simple to use arduino motion sensor. Power it up and wait 1-2 seconds for the sensor to get a snapshot of the still room. If anything moves after that period, the 'alarm' pin will go low. This sensor c...

SKU: DF-SEN0220 | Brand: DFRobot

The Gravity UART Infrared CO2 Sensor uses non-dispersive infrared (NDIR) technology to measure carbon dioxide concentrations from 0 to 50,000 ppm. It offers excellent selectivity with no oxygen dependency, built-in te...

SKU: DF-DFR0053 | Brand: DFRobot

This arduino Slide Position Sensor is based on straight-slip slide potentiometer sensor. The sensor is able to give provide the position of the slider which is often considered as a linear potentiometer . The ...

SKU: SF-COM-09542 | Brand: SparkFun

The QRE1113 is a small IR reflectance sensor. This sensor is often used in line following robots because, if it can sense if a surface is white or black. There are four pins on the QRE1113 - two control the IR em...

SKU: SF-ROB-09454 | Brand: SparkFun

The SparkFun QRE1113 Line Sensor Breakout (Digital) is a compact IR reflectance sensor board that outputs a digital signal based on surface reflectivity. It uses a capacitor discharge circuit — the faster the 10 nF ca...

SKU: SF-COM-09426 | Brand: SparkFun

A compact resistive analog joystick similar to those found on the PSP1000. Unlike traditional thumbstick joysticks, this one has a distinctive flat "slide" feel with a removable rubber thumb pad. Connect to an Arduin...

SKU: SF-SEN-09417 | Brand: SparkFun

This is a simple, thumbnail-size RFID tag. These tags are great for sensing presence, identification, etc., and they’re small, so they can be easily sewn into clothing or inserted into enclosures. Each tag comes with ...

SKU: SF-SEN-09405 | Brand: SparkFun

A simple-to-use MQ-6 gas sensor for detecting liquefied petroleum gas (LPG) — primarily propane and butane — in the air. The sensor detects concentrations from 200 to 10,000 ppm with high sensitivity and fast response...

SKU: SF-SEN-09404 | Brand: SparkFun

This is a simple-to-use compressed natural gas (CNG) sensor, suitable for sensing natural gas (composed of mostly Methane [CH4]) concentrations in the air. The MQ-4 can detect natural gas concentrations anywhere from ...

SKU: AF-333 | Brand: Adafruit

A 4-wire resistive touch screen digitiser (originally designed for the Nintendo DS Lite) that works with a stylus or fingertip. It can be used with any microcontroller that has 2 digital pins and 2 analogue input pins...

SKU: AF-5606 | Brand: Adafruit

The Adafruit ENS160 is a fully integrated metal-oxide (MOX) gas sensor from ScioSense, designed as a drop-in upgrade for the now-discontinued CCS811. It combines multiple MOX sensing and heating elements on a single c...

SKU: AF-5580 | Brand: Adafruit

The Adafruit MAX17048 LiPoly/LiIon Fuel Gauge and Battery Monitor gives you accurate battery voltage and charge percentage readings for your 1S 3.7–4.2V lithium polymer or lithium ion battery. Instead of guessing rema...

SKU: DF-SEN0223 | Brand: DFRobot

The Gravity Conductivity Sensor Switch module can be used to detect if an object has electrical conductivity. Its maximum detection value is 10MΩ. It can detect not only coins, wires, metal and other good conducto...

SKU: WS-31940 | Brand: Waveshare

Elevate your technological projects with our cutting-edge Long-wave IR Thermal Imaging Camera Module. Designed for seamless integration with Raspberry Pi and other development boards, this module is an ideal addition ...