Motors (DC, stepper, servo)

Multiple-output DC–DC converters are essential in a multitude of applications where different DC output voltages are required.This DC-DC step-down ...

Looking for a Robot Chassis?   Check out our 2 Wheel Robot Chassis.  Perfect for adding your own electronics to.  It comes with two motors which...

This is a DC12V independent control four-way solenoid valve, which has an inlet and four air outlets, you can individually control the outlet of ea...

This is a low cost clone of the open-source EasyDriver is a simple to use stepper motor driver, compatible with anything that can output a digital ...

INTRODUCTIONThis is a 20W DC-DC buck converter power module with 7~24V input and 5V/4A output(Max). The high conversion efficiency and on-board 6 o...

This Power Module is a small size 5A 350KHz 25V Buck DC to DC Converter. It can convert any DC voltage between 3.6V-25V to a selectable voltage f...

INTRODUCTION A new micro metal gear motor with a difference! This motor comes with a built-in encoder which measures ...

Description:Type: Emax ES08MA IISize: 23 x 11.5 x 24 mm (1.25 x.45 x.94in)Weight: 12g / 0.42ozWorking voltage: 4.8V~6.0VWorking current: 200mA/...

This cooling fan is designed for Raspberry Pi Model B+ / Raspberry Pi B. With this useful fan, you don’t need to worry about your pi becoming too h...

The servo tester and controller can be used as a signal generator for electronic speed controllers.   If you are looking for a low-cost way to g...

Run four solenoids, two DC motors or one bi-polar or uni-polar stepper with up to 600mA per channel using the L293D. These are perhaps better kn...

What is a stepper motor? Stepper motor is a brushless DC electric motor that divides a full rotation into a number of equal steps The motor's p...

Specification:Model: Mini 130 Vibration MotorMotor size: 25*20mmMotor height: 15.3mmVoltage range: DC 3V-6VRated voltage: DC 3.7VRated current: ...

When a servo is operated under complex circumstances such as robot and model, it may get stuck, be burned or damaged due to external forces, which ...

3V Vertical water pump is a kind of DC micro submersible pump. Equipped with male and female Dupont line connectors, it can apply to the fountain...

Add more power to your robot with this metal-geared MG90S servo. The tiny little servo can rotate approximately 90 degrees (45 in each direction), ...

Your power supply problems just got SOLVED! This little circuit board may look tiny but inside is a high efficiency DC/DC step-down converter which...

 DC3V 612 6*12MM Micro DIY Helicopter Coreless DC Motor  

The DRV2605 from TI is a fancy little motor driver. Rather than controlling a stepper motor or DC motor, its designed specifically for controlli...

This 20W adjustable DC-DC boost converter with a digital display is based on the professional boost chip and supports 3~32V power input, 5~35V ou...

A vibration motor! This itty-bitty, shaftless vibratory motor is perfect for non-audible indicators. Use in any number of applications to indicate ...

If you need to connect a battery pack or wired power supply to a board that has a DC jack - this adapter will come in very handy! There is a 2.1mm ...

This is a 9V battery pack with on/off switch and a pre-attached 5.5mm/2.1mm center-positive barrel plug. Use this to battery-power your Arduino ...

This adapter allows you to connect a barrel jack connector to bare wires. One end has screw terminals and the other has a 5.5x2.1mm, center-positiv...