Jumpers & Wires

These five-pin housings work with our wires with pre-crimped terminals to let you quickly make custom cables that mate with various 0.1"-spaced ...

This is a simple two wire cable. Great for jumping from board to board or just about anything else. There is a 2-pin JST connector on one end, bare...

INTRODUCTION The digital sensor cables are especially designed for our popular IO Expansion shield and sensors. It con...

These Male/Male Jumper Wires are handy for making wire harnesses or jumpering between headers on PCB's. These premium jumper wires are 12" (3...

The Gravity 4Pin IIC/I2C/UART sensor cable is a standard Gravity series 4-Pin cable with 30cm length. One side is PH2.0-4p connector and the ot...

A wire stripper is an essential tool for any electronics work bench, and this multi-purpose stripper and cutter makes removing protective covers ea...

The Pogo Pin Probe Clip with 2x5 0.05" pitch SWD spacing is a great way to test and connect with pin-point accuracy without soldering! It's sort of...

These jumper cables are exactly what you need to connect common 0.1" header devices together. Sure you can tape together individual 1x1 header jump...

These jumper cables are exactly what you need to connect common 0.1" header devices together. Sure you can tape together individual 1x1 header jump...

These jumper cables are exactly what you need to connect common 0.1" header devices together. Sure you can tape together individual 1x1 header j...

When 0.1" is too big, and JST PH's too chunky, this ultra-slim 1.25mm connector cable is a reliable alternative. These are 1.25mm pitch but have a ...

These solid 2.0mm pitch connector cable pairs are great when you need something that can carry a couple of amps of current and are easy to connect ...

The AM2301B is a nice but inexpensive temperature and humidity sensor from the same folks that brought us the AM2302. In fact, this enclosed senso...

If you want to do more with the BBC micro:bit, getting those pins from the card-edge connector is going to be your first hurdle. Unlike many dev-bo...

These solid 1.25mm pitch connector cable pairs are great when you need something that can carry a couple of amps of current and are easy to connect...

This kit is prefect for your circuit hook-ups.   With 10 Red, 10 Black and 10 Yellow Male to Male jumper wires you can easily lay out your circu...

When 0.1" is too big, and JST PH's too chunky, this ultra-slim 1.25mm connector cable is a reliable alternative. These are 1.25mm pitch but have a ...

When 0.1" is too big, and JST PH's too chunky, this ultra-slim 1.25mm connector cable is a reliable alternative. These are 1.25mm pitch but have a ...

This Gravity: I2C HUB module is designed to connect up to 8 I2C devices to a main-controller, which allows you easily to hook up multiple I2C devic...

Listen up! This single  2.8" x 1.2" speaker is the perfect addition to any audio project where you need 4 ohm impedance and 3W or less of power. We...

These are various leaded cables for attaching to multimeters, power supplies, oscilloscopes, function generators, etc. Cables come in red/black pairs.

In this world nothing can be said to be certain, except we need headers, headers, and more headers!Each pack contains ten blue 36-pin 0.1" pitch br...

In this world nothing can be said to be certain, except we need headers, headers, and more headers! Each pack contains ten candy-colored 36-p...

  INTRODUCTION   This product is high temperature resistant silicone rubber copper wire with 18AWG and 0.75mm2. It is made of fine tin-...