ICs and Microchips

SKU: LB-LR0285 | Brand: Little Bird

Feature: 0.5°C Ensured Accuracy (+25°C) Suitable for Remote Applications Low Cost Due to Wafer-Level Trimming Operates from 4 to 30 V Less than 60-μA Current Drain Low Self-Heating, 0.08°C in Still Air Low Impedance O...

SKU: SF-COM-15105 | Brand: SparkFun

This diode-transistor photocouplers consist of an LED, optically coupled to a high speed photodetector to transmit electrical signals between circuits while still isolating your system from higher voltages. The 6N137 ...

SKU: AF-2164 | Brand: Adafruit

The classic L7805 linear voltage regulator in a TO-220 package, capable of delivering a clean, regulated 5.0 V output (±2%) from an input voltage of 7–35 V. With built-in current limiting and thermal shutdown protecti...

SKU: TB-ZL3386 | Brand: Little Bird

LM386N-1 - 8 - Low voltage 325mW amplifier Specifications active mount type Through Hole active connector type ...

SKU: AF-2166 | Brand: Adafruit

A low-dropout (LDO) 3.3 V linear voltage regulator based on the ST L4931 in a TO-92 package. With just 0.4 V dropout, it delivers a clean, regulated 3.3 V output from input voltages as low as 3.7 V — well suited for s...

SKU: AF-2717 | Brand: Adafruit

The TCA9548A 1-to-8 I2C multiplexer solves the common problem of needing multiple I2C devices with the same address on a single bus. It acts as a gatekeeper, routing I2C traffic to any of its eight downstream channels...

SKU: SF-BOB-09056 | Brand: SparkFun

A breakout board for the CD74HC4067 16-channel analogue/digital multiplexer/demultiplexer. This IC internally routes a common signal pin (SIG) to one of 16 channel pins, working with both analogue and digital signals ...

SKU: SF-BOB-12918 | Brand: SparkFun

You’ve always wanted to output analog voltages from a microcontroller, the MCP4725 is the DAC that will let you do it! The MCP4725 is an I2C controlled Digital-to-Analog converter (DAC). A DAC allows you to send analo...

SKU: AF-1875 | Brand: Adafruit

Because the Arduino (and Basic Stamp) are 5V devices, and most modern sensors, displays, flash cards and modes are 3.3V-only, many makers find that they need to perform level shifting/conversion to protect the 3.3V de...

SKU: SF-COM-08636 | Brand: SparkFun

The MCP3002 is a 10-bit analog-to-digital converter (ADC) with a simple SPI interface, available in a breadboard-friendly 8-pin DIP package. Use it to add analog input capability to microcontrollers that lack an ADC, ...

SKU: SF-COM-00527 | Brand: SparkFun

The LM317TG is a three-terminal adjustable positive voltage regulator with an output range of 1.2V to 37V and up to 1.5A output current. Only two external resistors are needed to set the desired output voltage, making...

SKU: SF-COM-00315 | Brand: SparkFun

The SN754410 is a quad half H-bridge motor driver IC capable of driving DC motors, stepper motors, and other inductive loads. It accepts TTL 5V logic inputs and can drive motors from 4.5V to 36V at up to 1A continuous...

SKU: AF-3296 | Brand: Adafruit

The Adafruit DS1307 Real Time Clock breakout keeps accurate time even when your microcontroller loses power or is reprogrammed. This battery-backed I2C RTC is one of the most widely used clock chips, making it a relia...

SKU: AF-732 | Brand: Adafruit

Add another 16 pins to your microcontroller using a MCP23017 port expander. The MCP23017 uses two i2c pins (these can be shared with other i2c devices), and in exchange gives you 16 general purpose pins. You can...

SKU: LB-LS7756 | Brand: Little Bird

Packing list: 10 × White LEDs10 × Yellow LEDs10 × Blue LEDs10 × Green LEDs10 × Red LEDs1 × RGB LED2 × Photoresistors (LDR)1 × Thermistor5 × Rectifier Diodes (1N4007)5 × NPN Transistors (PN2222)1 × Optocoupler IC ...

SKU: AF-5626 | Brand: Adafruit

Need to use multiple I2C devices that share the same address? The PCA9548 8-Channel STEMMA QT / Qwiic I2C Multiplexer lets you connect up to eight same-address I2C devices with completely solderless wiring. Nine JST S...

SKU: AF-4489 | Brand: Adafruit

Run two solenoids, or a single DC motor with up to 800mA per channel using the super-simple L9110H H-bridge driver. This bridge chip is an 8 DIP package so it's easy to fit onto any breadboard or perfboard.Each chip c...

SKU: AF-1083 | Brand: Adafruit

Add high-speed analog-to-digital conversion to any microcontroller with the ADS1015 breakout. This 12-bit ADC delivers 3,300 samples per second over I2C, with four single-ended or two differential input channels and a...

SKU: PI-COM0206 | Brand: Pimoroni

The MCP3008 is a 10-bit analogue-to-digital converter with eight single-ended input channels, communicating via SPI. It's a popular choice for adding analogue inputs to the Raspberry Pi and other digital-only boards —...

SKU: AF-1429 | Brand: Adafruit

Control 24 channels of 12-bit PWM output with the Adafruit TLC5947 breakout board. Designed for LED control, this SPI-driven board delivers constant-current open-drain outputs that keep brightness consistent even if t...