Gas & Air Quality Sensors

SKU: DF-SEN0129 | Brand: DFRobot

INTRODUCTION This is an Arduino CH4 gas sensor. It uses MQ4 probe which is able to detect nature gas, CH4. It is less sensitivity in detecting alcohol, cooking fumes, and cigarette smok...

SKU: DF-SEN0133 | Brand: DFRobot

This is an Arduino hydrogen gas sensor. It has high sensitivity to Hydrogen (H2) and less sensitivity to alcohol, LPG,cooking fumes . Hydrogen gas is highly flammable and will burn in air at a very wide range...

SKU: LB-LR0205 | Brand: Little Bird

An alcohol sensor module for Arduino with both digital (TTL) and analog output. It detects alcohol vapour in the 10–1000 PPM range, with analog output voltage increasing proportionally with concentration. The module a...

SKU: DF-SEN0467 | Brand: DFRobot

This is a sensor that detects hydrogen sulfide concentration and supports three output modes: analog, I2C, and UART. The probe has been calibrated at the factory, which can quickly and accurately measure the concentra...

SKU: DF-SEN0130 | Brand: DFRobot

The Gravity MQ5 gas sensor is highly sensitive to LPG, natural gas, and town gas, with lower sensitivity to alcohol, cooking fumes, and cigarette smoke. The analogue output is proportional to gas concentration, and se...

SKU: PL-1479 | Brand: Pololu

This carrier board is designed to work with any of the MQ-series gas sensors, simplifying the interface from 6 to 3 pins—ground, power and analog voltage output—that are broken out with a 0.1" spacing, making the boar...

SKU: DF-SEN0134 | Brand: DFRobot

The Gravity MQ-9 gas sensor detects carbon monoxide (CO) and combustible gases including methane and propane. It uses a semiconductor SnO2 sensing element that cycles between high and low temperatures — detecting CO a...

SKU: DF-SEN0376 | Brand: DFRobot

This is an Arduino compatible alcohol sensor module from DFRobot with a 0-5ppm measuring range, supporting I2C and UART outputs. Aiming at fast and accurate detection of alcohol gas concentration in the air,...

SKU: EF-EF04060 | Brand: ElecFreaks

The Octopus MQ3 Alcohol Sensor Brick from ElecFreaks is an analogue gas sensor module with high sensitivity to alcohol vapour. It outputs an analogue voltage proportional to the detected alcohol concentration, making ...

SKU: PL-1634 | Brand: Pololu

The MQ-3 is a semiconductor gas sensor that detects alcohol vapour at concentrations from 0.04 mg/L to 4 mg/L — a range suitable for building a breathalyser. It provides a simple analog voltage output that requires on...

SKU: SF-SEN-08880 | Brand: SparkFun

The MQ-3 is an alcohol gas sensor suitable for detecting alcohol concentration in the air, similar to a breathalyser. It provides an analog resistive output based on alcohol concentration, with high sensitivity and fa...

SKU: SF-SEN-09405 | Brand: SparkFun

A simple-to-use MQ-6 gas sensor for detecting liquefied petroleum gas (LPG) — primarily propane and butane — in the air. The sensor detects concentrations from 200 to 10,000 ppm with high sensitivity and fast response...

SKU: SF-SEN-09404 | Brand: SparkFun

This is a simple-to-use compressed natural gas (CNG) sensor, suitable for sensing natural gas (composed of mostly Methane [CH4]) concentrations in the air. The MQ-4 can detect natural gas concentrations anywhere from ...

SKU: DF-SEN0473 | Brand: DFRobot

This is a sensor that detects hydrogen concentration and supports three output modes: analog, I2C, and UART. The probe has been calibrated at the factory, which can quickly and accurately measure the concentration of ...

SKU: DF-SEN0474 | Brand: DFRobot

This is a sensor that detects hydrogen chloride concentration and supports three output modes: analog, I2C, and UART. The probe has been calibrated at the factory, which can quickly and accurately measure the concentr...

SKU: SF-SEN-17052 | Brand: SparkFun

The MQ-136 is a Hydrogen Sulfide detection sensor with a sensing range of 1 - 200ppm. The sensing element is SnO2, which has lower conductivity in clean air. When H₂S gas exists, the sensor’s conductivity gets higher ...

SKU: SF-SEN-17053 | Brand: SparkFun

The MQ-137 is an ammonia (NH3) gas sensor from Winsen, designed to detect ammonia concentrations in the air. The sensing element is tin dioxide (SnO2), which has lower conductivity in clean air and increases in conduc...

SKU: DF-SEN0131 | Brand: DFRobot

INTRODUCTION This is an Arduino Propane Gas Sensor. It uses MQ6 probe to detect iso-butane, propane and liquefied petroleum gas (LPG). It is less sensitive with alcohol, cooking fumes an...

SKU: DF-SEN0128 | Brand: DFRobot

An analogue alcohol gas sensor based on the MQ-3 probe, designed for use with Arduino and other microcontrollers. The sensor outputs a voltage proportional to the concentration of alcohol vapour in the surrounding air...

SKU: SS-101020044 | Brand: Seeed Studio

Alcohol sensor is semiconductor sensor for alcohol detection. It has good sensitivity and fast response to alcohol, suitable for portable alcohol detector. Specifications Power requirements: 5 VDC @ ~120 ...