Breakouts

This interface shield supports multi-interfaces, SPI interface (directly connected Shiftout module, SPI LCD display module, SPI LED display m...

At sometime or another you may run out of pins on your Arduino board and need to extend it with shift registers.  With this shift out module which ...

What's better than a single LED? Lots of LEDs! A fun way to make a small display is to use an 8x8 matrix or a 4-digit 7-segment display. Matrice...

This version of the QRE1113 breakout board features a digital output, using a capacitor discharge circuit to measure the amount of reflection. T...

This version of the QRE1113 breakout board features an easy-to-use analog output, which will vary depending on the amount of IR light reflected ...

Say hello to our 0.96" 160x80 Color TFT Display w/ MicroSD Card Breakout – we think it's T-F-Terrific! It's the size of your thumbnail, with glo...

This lovely little display breakout is the best way to add a small, colorful and bright display to any project. Since the display uses 4-wire SP...

DFRobot FireBeetle series is the low-power consumption micro-controller intentionally designed for Internet of Things (IoT). T...

Add some jazz & pizazz to your project with a color capactive touchscreen LCD. This TFT display is big (2.8" diagonal) bright (4 white-LED b...

Give your 40 pin, 0.5mm pitch, devices a strrrreeeetch with this extension board.  This 40pin FPC extension board has two 40-pin flex connectors (b...

DFRobot FireBeetle is a low-power consumption micro-controller intentionally designed for Internet of Things (IoT). This series micro-control...

Add heat-vision to your project and with an Adafruit AMG8833 Grid-EYE Breakout! This sensor from Panasonic is an 8x8 array of IR thermal sensors. W...

This is a 128x64 liquid crystal display that support Chinese character , English characters and even graphics, very suitable for interactive wo...

DFRobot FireBeetle is a low-power consumption micro-controller intentionally designed for Internet of Things (IoT). This series micro-controller...

This breakout board will solve all your power-monitoring problems. Instead of struggling with two multimeters, you can just use the handy INA219B c...

This is a breakout board for our non-isolated, 6A DC-to-DC Converter Module. The module can convert any DC voltage between 4.5-14VDC to a selectabl...

Pimoroni's Pico HAT Hacker gives you full access to all 40 pins on your Pi, broken out at the top. It's a super-skinny 0.8mm PCB, so you can sol...

Qwiic, or STEMMA QT, is a very efficient way to quickly prototype an idea, but a lot of Qwiic/Stemma QT driver boards only have one port, and devi...

This IIC to Dual UART module offers data transmission rate up to 1Mbps, and each sub UART has independent 256-byte FIFO hardware buffer for transmi...

Simple breakout board for the 3.5mm audio jack. Use this breakout (shipped bare) to allow breadboard or SIP access to the super-common 3.5mm aud...

Grow your projects on Breakout Garden. It's the easiest way to use breakouts with your Raspberry Pi. There's no soldering required, just pop up ...

A really sophisticated and accurate colour and luminance sensor breakout that's Raspberry Pi and Arduino compatible. As well as detecting RGB...

An all-singing, all-dancing time of flight distance sensor that uses PEW PEW LASERS (low-powered ones), our VL53L1X breakout is easy to use with...

A preposterous pile of peripherals on your Pi! Mix and match 3 HATs or 5 pHATs into a platter of functionality. Use pHAT Stack for specific s...