Brands and Manufacturers

SKU: PI-ABX00012 | Brand: Pimoroni

The Arduino MKR Zero brings 32-bit power to the compact MKR form factor, with the standout feature of an onboard SD card connector with dedicated SPI interface for playing music and audio files directly — no extra har...

SKU: AF-1392 | Brand: Adafruit

This single button keyfob remote goes with our three basic 315MHz RF receiver modules. It will work with all of them, sending out one command that matches with the second output on the receiver. Its small and light...

SKU: PL-2811 | Brand: Pololu

The Mini MOSFET Slide Switch is a compact, breadboard-compatible power switch module that uses a pair of P-channel MOSFETs to deliver continuous currents up to 4.3 A at 4.5–32 V. It features built-in reverse-voltage p...

SKU: PL-2765 | Brand: Pololu

The Adafruit Perma-Proto Quarter-Sized Breadboard PCB (3-Pack) provides three compact prototyping boards that bridge the gap between solderless breadboards and permanent soldered circuits. Each board has 15 rows of 5-...

SKU: PL-2458 | Brand: Pololu

The QTR-1A reflectance sensor carries a single infrared LED and phototransistor pair in an inexpensive, tiny 0.5" x 0.3" module that can be mounted almost anywhere and is great for edge detection and line fo...

SKU: PL-2453 | Brand: Pololu

A compact carrier board for the Allegro ACS711EX Hall effect-based linear current sensor with overcurrent fault output. It measures bidirectional current up to ±31 A with a proportional analogue voltage output centred...

SKU: AF-2308 | Brand: Adafruit

A 100 mm (4″) flexible WiFi antenna with approximately 4 dBi gain and a U.FL (IPEX) connector. The flexible design lets you bend and position the antenna to suit your enclosure or project layout, while the U.FL connec...

SKU: AF-2942 | Brand: Adafruit

When your little robot needs someone to lean on, it can lean on this support wheel. Perfect for use with 2-wheeled robots that need a third-point of support, this Support Wheel comes attached to a mounting plate and w...

SKU: SF-CAB-00501 | Brand: SparkFun

These are various leaded cables for attaching to multimeters, power supplies, oscilloscopes, function generators, etc. 5 pairs of IC Hook to IC Hook test leads. Comes with Black, Red, Blue, Green, and Yellow colored l...

SKU: AF-2964 | Brand: Adafruit

The Mini Skinny NeoPixel strip features 60 individually addressable RGB LEDs per metre on an ultra-narrow 7.5 mm wide flexible PCB (5 mm without casing). This is the black PCB version — identical specs to the white PC...

SKU: PL-1161 | Brand: Pololu

A battery holder for eight AA cells, arranged as two back-to-back four-cell holders. Provides up to 12V (with alkaline cells) in a compact, stackable form factor. Specifications Cell Type – AA Capacity – 8 cells ...

SKU: PL-1155 | Brand: Pololu

A compact enclosed battery holder for six AA batteries, providing approximately 9V (alkaline) or 7.2V (NiMH rechargeable) from a series configuration. Features bare wire leads for flexible integration into your projec...

SKU: DF-TOY0055 | Brand: DFRobot

A beginner-friendly DIY soldering kit that lets kids build six adorable zoo animal circuits. Each pre-cut PCB animal gets a colour-changing RGB LED and coin cell battery soldered on the back, bringing it to life with ...

SKU: SF-WIG-13118 | Brand: SparkFun

The SparkFun Servo Trigger is a compact robotics board that simplifies control of hobby RC servo motors — no programming required. When an external switch or logic signal changes state, the board tells an attached ser...

SKU: TB-ZD0670 | Brand: Little Bird

One of the most common lights used in caravans up until quite recently, is the 16W 2D fluoro. The problem with these is not only do they draw a lot of power for the light they produce, but they also blow very ...

SKU: AF-615 | Brand: Adafruit

This gold-eye sharps needle set is perfect for hand-sewing with conductive thread and wearable electronics parts. The pack includes 20 needles in sizes #3 to #9, giving you the right needle for any e-textiles or gener...

SKU: AF-758 | Brand: Adafruit

Handy for making wire harnesses or jumpering between headers on PCB's. These premium jumper wires are 6" (150mm) long and come in a 'strip' of 40 (4 pieces of each of ten rainbow colors). They have 0.1" male header...

SKU: SF-COM-09850 | Brand: SparkFun

A pack of 25 super bright white through-hole LEDs, ideal for indicators, lighting effects, and general-purpose use in electronics projects. Supplied in a reusable ESD-safe bag. Key Features Super Bright White – Hig...

SKU: AF-1649 | Brand: Adafruit

Heat shrink is the duct tape of electronics which I guess makes this heat shrink the colorful and exciting duct tape they sell at craft stores.  This heat shrink comes in six different colors - red, blue,...

SKU: AF-2328 | Brand: Adafruit

Adafruit DotStar LED strips use 2-wire SPI instead of the single-wire protocol used by NeoPixels, allowing much faster data rates (up to 32 MHz) and a 20 KHz PWM refresh rate. This makes DotStars ideal for persistence...