Arduino

SKU: SF-SEN-12728 | Brand: SparkFun

Infrared proximity sensor made by Sharp. Part # GP2Y0A41SK0F has an analog output that varies from 3.1V at 4cm to 0.3V at 30cm with a supply voltage between 4.5 and 5.5VDC. The sensor has a Japanese Solderless Termina...

SKU: DF-DFR0356 | Brand: DFRobot

INTRODUCTION The Bluno Beetle Shield expands the Beetle's single analog and digital I/O pins to the 3 pin "gravity" interface, giving more power and ground connections and making it easier to attach gravity inter...

SKU: DF-DFR0423 | Brand: DFRobot

INTRODUCTION This module is a self-locking switch. Press the button to turn it to the "on" state and press it again to turn it to the "off" state. The board has immersion gold plating and...

SKU: DF-SEN0002 | Brand: DFRobot

The URM04 Ultrasonic sensor is developed based upon our popular URM37 ultrasonic sensor, it is using RS485 interface which allows multiple sensors to be used simultaneously . The RS485 interface allows a number of...

SKU: DF-DFR0032 | Brand: DFRobot

Here is the simplest sound making module that you can use High/Low to drive it. Just change the frequency it buzz, you can hear different sound. It is widely used on your daily application, like PC, refrigerator,...

SKU: DF-DFR0072 | Brand: DFRobot

At sometime or another you may run out of pins on your Arduino board and need to extend it with shift registers.  With this shift out module which is based on 74HC595. The datasheet refers to the 74HC595 as an "8...

SKU: AF-715 | Brand: Adafruit

The Adafruit I²C Controlled + Keypad Shield Kit lets you drive a 16×2 character LCD and read 5 navigation buttons using only two I²C pins on your Arduino. This frees up the 9+ digital pins that a standard LCD connecti...

SKU: SF-PRT-09387 | Brand: SparkFun

A pack of 10 premium male-to-male jumper wires, 12" (30cm) long. Compatible with breadboards, Arduino headers, and any 0.1" (2.54mm) pitch prototyping board. Assorted colours for easy circuit identification. Specific...

SKU: LB-LS7942 | Brand: Little Bird

Robot Arm Vacuum Pump & Valve Kit – PWM Electronic Switch Controller with Suction Cup (Arduino Compatible)Take your robotics projects to the next level with this compact vacuum suction kit, designed for robotic arms, ...

SKU: WS-26117 | Brand: Waveshare

This compact 0.85-inch IPS LCD display module gives you a small full-colour screen for embedded interfaces, status readouts and other maker projects. It uses an SPI interface, making it a practical match for microcont...

SKU: DF-SEN0678 | Brand: DFRobot

This Gravity air quality module uses Sensirion’s STCC4 gas sensing chip to directly measure carbon dioxide with the thermal conductivity measurement principle. It is designed for compact, cost-effective indoor monitor...