Arduino

SKU: AF-161 | Brand: Adafruit

CdS cells are little light sensors. As the squiggly face is exposed to more light, the resistance goes down. When its light, the resistance is about 5-10KΩ, when dark it goes up to 200KΩ. To use, connect one side o...

SKU: DF-FIT0365 | Brand: DFRobot

 INTRODUCTION Premium quality jumper wires for prototyping. Made with 26AWG multi-strand wire and sturdy male pins. Each jumper wire is approximately 210mm in length. Each pack comes with 30 jumper wires in a...

SKU: DF-DFR0296 | Brand: DFRobot

The Bluno Nano combines an Arduino Nano-compatible ATmega328 microcontroller with an integrated TI CC2540 Bluetooth 4.0 (BLE) module in a compact 53 × 19 mm form factor. It enables wireless communication, wireless pro...

SKU: DF-DFR0332 | Brand: DFRobot

Make an air aerial propeller vessel, a cooling system, or spinning machine with this small fan module. It comes with a propeller, a 15,000 rpm motor and cable. Add flavor to your own interesting projects with this ...

SKU: AF-1785 | Brand: Adafruit

A medium surface transducer that turns any flat surface — tables, walls, panels — into a speaker. Unlike traditional cone speakers, a voice coil wrapped around a metal rod causes vibration that transfers directly to t...

SKU: SF-SEN-12650 | Brand: SparkFun

The AD8232 SparkFun Single Lead Heart Rate Monitor is a cost-effective board used to measure the electrical activity of the heart. This electrical activity can be charted as an ECG or Electrocardiogram and output as a...

SKU: LB-LR0178-350 | Brand: Little Bird

SKU: AF-5578 | Brand: Adafruit

The BS612 is a compact, fully configurable mini PIR motion sensor that detects movement from approximately 3–8 metres away with a 120° detection spread. Its small form factor makes it ideal for unobtrusive motion-sens...

SKU: DF-SEN0502 | Brand: DFRobot

This looks like a potentiometer, but it’s an encoder switch. It is a cascadable 360 ° rotary encoder switch with 20 pulses per revolution, and each pulse corresponds to a detent. There are LED lights set for each dete...

SKU: DF-TEL0142 | Brand: DFRobot

When building a project that needs to transmit some simple signals wirelessly, have you been bothered by the any of the following problems: Bluetooth's cumbersome AT command configuration and high cost, Wifi's signal ...

SKU: SF-SEN-18367 | Brand: SparkFun

A sealed, waterproof DS18B20 digital temperature probe for precise measurements in wet or harsh environments. The sensor communicates over a 1-Wire interface, requiring just one data pin (plus ground) to connect to yo...

SKU: EC-SEL71220A | Brand: Elecrow

A current sensing module based on the Allegro ACS712 Hall effect sensor, capable of accurately measuring both AC and DC current up to ±20 A. The module outputs a proportional analogue voltage that can be read directly...

SKU: DF-FIT0720 | Brand: DFRobot

These patch test hooks provide a solderless way to make signal and low-current connections between boards, sensors, and modules. The hook clips grab onto pins, pads, and component legs — perfect for prototyping with c...

SKU: EC-SEA0001T | Brand: Elecrow

The Crowtail Starter Kit for Arduino is a beginner-friendly electronics kit built around the Crowduino Uno-SD board and the Crowtail modular connector system. With 22 plug-and-play modules and over 20 guided tutorials...

SKU: LB-EAGLED-BUZZ-KIT | Brand: Little Bird

The EagLED is Little Bird Electronics' own Arduino-compatible wearable development kit, designed from the ground up for e-textile projects. It packs a microcontroller, LEDs, light sensor, push button, and buzzer onto ...

SKU: EC-ACS70028DH | Brand: Elecrow

The Dual Channel H-Bridge Motor Shield is composed of 2 discrete MOSFET H-bridge, designed to drive two DC motor with max current 8A. It is made up of 8 N-channel MOSFET IRF3205S and 4 pcs of half bridge motor control...

SKU: EC-MCA03168A | Brand: Elecrow

The Nano 168 is a compact, breadboard-friendly Arduino-compatible development board based on the ATmega168 microcontroller. It offers the same functionality as the Arduino Nano in a small DIP form factor, with 14 digi...

SKU: EF-EF04093 | Brand: ElecFreaks

Octopus Analog UV sensor (GUVA-S12SD) is the UV electric brick in our Octopus series, the basic design is from the Octopus electric bricks and the setting of its outlook, the PCB fixing hole and the connectors are the...

SKU: LB-LS1673 | Brand: Little Bird

This Potentiometer Module is from our Micro:bit 24 bit kit. You're probably already familiar with using a potentiometer as they are commonly found on many electrical devices, such as in audio equipment where they a...

SKU: LB-LR07 | Brand: Little Bird

A comprehensive collection of 37 different sensors and modules for Arduino, covering a wide range of inputs and outputs for electronics projects. Everything comes neatly organised in a clear plastic storage case. Fro...