Arduino Sensors

SKU: DF-DFR0031-B | Brand: DFRobot

Piranha LED light module (Blue) , and special sensors Arduino board and ambient light sensor extension combination, can be used in the interaction with the light works. When the LED light module connected to A...

SKU: DF-SEN0097 | Brand: DFRobot

This is a BH1750 light intensity sensor breakout board with a 16 bit AD converter built-in which can directly output a digital signal, there is no need for complicated calculations. This is a more acurate and easier ...

SKU: DF-SEN0104 | Brand: DFRobot

This is a cool touch sensor from DFRobot. You can hook it up to the IO Expansion shield (for arduino) directly. It includes a metallic tape with a sticky side. This make it possible for you to place your sensors...

SKU: DF-SEN0132 | Brand: DFRobot

INTRODUCTION This is an Arduino Carbon Monoxide Sensor. It uses MQ7 probe to detect Carbon Monoxide (CO) concentrations in the air from 20 to 2000ppm. The sensitivity ca...

SKU: DF-FIT0227 | Brand: DFRobot

The MQ7 is a simple-to-use Carbon Monoxide (CO) sensor suitable for detecting CO concentrations in the air. It offers a wide detection range from 20 to 2000 ppm, making it ideal for safety monitoring and air quality p...

SKU: DF-SEN0138-R | Brand: DFRobot

A miniature snap-action switch, also trademarked and frequently known as a micro switch, is an electric switch that is actuated by very little physical force.Micro switches are very widely used; among their appl...

SKU: SF-SEN-00242 | Brand: SparkFun

The Sharp GP2Y0A21YK is an infrared proximity sensor with an analogue voltage output that varies with distance — from 3.1 V at 10 cm to 0.4 V at 80 cm. It uses an IR emitter and position-sensitive detector to measure ...

SKU: SF-SEN-13322 | Brand: SparkFun

The SparkFun Soil Moisture Sensor is a simple breakout for measuring the moisture in soil and similar materials. The soil moisture sensor is pretty straight forward to use. The two large exposed pads function as probe...

SKU: AF-386 | Brand: Adafruit

The DHT11 is a basic, ultra low-cost digital temperature and humidity sensor. It uses a capacitive humidity sensor and a thermistor to measure the surrounding air, and spits out a digital signal on the data pin (no an...

SKU: DF-SEN0177 | Brand: DFRobot

The Gravity Laser PM2.5 Air Quality Sensor uses laser scattering to measure suspended particulate matter concentrations in the air. It detects particles from 0.3 to 10 µm in diameter and outputs digital concentration ...

SKU: SF-BOB-10160 | Brand: SparkFun

Here is a real time clock based on the DS3234 Real Time Clock IC. The DS3234 is a low-cost, extremely accurate SPI bus real-time clock with an integrated temperature-compensated crystal oscillator and crystal. Th...

SKU: SF-SEN-09674 | Brand: SparkFun

This very long force sensitive resistor - over 2 feet - has a sensing area of 0.25x24". This FSR from Interlink Electronics will vary its resistance depending on how much pressure is being applied to the sensing area....

SKU: DF-SEN0203 | Brand: DFRobot

The DFRobot heart rate sensor is a thumb-sized heart rate monitor designed for Arduino microcontrollers. This sensor is a pulse sensor which is developed based on PPG (PhotoPlethysmoGraphy) techniques. This ...

SKU: SF-COM-09542 | Brand: SparkFun

The QRE1113 is a small IR reflectance sensor. This sensor is often used in line following robots because, if it can sense if a surface is white or black. There are four pins on the QRE1113 - two control the IR em...

SKU: SF-SEN-08685 | Brand: SparkFun

This is a piezoresistive force sensor from Tekscan. The harder you press, the lower the sensor’s resistance. Pressing hard, the resistance changes from infinite to ~300k. The sensor itself is thin and flexible, but th...

SKU: DF-SEN0648 | Brand: DFRobot

The TOFSense F2P is a professional-grade laser distance sensor using dTOF (Direct Time-of-Flight) technology. With 50m range, ±3cm accuracy, and 100Hz refresh rate, it's engineered for drones, traffic monitoring, indu...

SKU: AF-6420 | Brand: Adafruit

The Adafruit SPA06-003 is an affordable barometric pressure and temperature sensor from Goertek, ideal for basic environmental sensing and DIY quadcopter builds. It measures 300–1100 hPa (approximately −500 to +9000 m...

SKU: SF-GPS-28138 | Brand: SparkFun

The SparkPNT GNSS Flex Module features the Septentrio mosaic-X5, an industrial-grade multi-band, multi-constellation GNSS receiver capable of centimetre-level RTK positioning accuracy. Designed for demanding applicati...

SKU: SF-SEN-28798 | Brand: SparkFun

  This is the HC-SR04 ultrasonic distance sensor, now in Red! This economical sensor offers non-contact measurement functionality ranging from 2cm to 400cm, with a ranging accuracy of up to 3mm. Each HC-SR04 ...

SKU: DF-SEN0672 | Brand: DFRobot

The Benewake TFS20-L is an ultra-compact ToF LiDAR sensor weighing just 1.35g. With 20m range, centimetre-level accuracy, and 100K LUX sunlight resistance, it's designed for drones, robots, and space-constrained appli...