All Products
Browse the full range of electronics, components, and maker supplies available at Little Bird Electronics. From microcontrollers and sensors to connectors, tools, and development boards — everything you need for your next project is right here.
Whether you're a hobbyist, educator, student, or professional engineer, our catalogue covers robotics, IoT, STEM kits, 3D printing accessories, and thousands of electronic components with fast shipping across Australia.
Pico HAT Hacker
SKU: PR-PIM300 | Brand: Little Bird
The Pico HAT Hacker is an ultra-thin breakout board that gives you full access to all 40 GPIO pins on your Raspberry Pi. At just 0.8 mm thick, it solders directly onto the Pi's header pins while leaving enough pin hei...
Delivered by Wed 5 Aug
MCP4725 Breakout Board - 12-Bit DAC w/I2C Interface
SKU: AF-935 | Brand: Adafruit
The MCP4725 breakout board provides a 12-bit digital-to-analogue converter (DAC) over I2C. Send a digital value and the VOUT pin outputs the corresponding analogue voltage — ideal for generating waveforms, adjustable ...
Delivered by Wed 5 Aug
5M Flexible el wire with battery holder 5mm - Blue
SKU: LB-LR0335-B | Brand: Little Bird
This 5-metre length of EL wire (electroluminescent wire) glows a vibrant blue when powered by the included battery-operated inverter. EL wire is a flexible, phosphor-coated wire that produces a cool, even glow similar...
Delivered by Wed 5 Aug
5M Flexible el wire with battery holder 5mm - Pink
SKU: LB-LR0335-PI | Brand: Little Bird
This 5-metre length of EL wire (electroluminescent wire) glows a vibrant pink when powered by the included battery-operated inverter. EL wire is a flexible, phosphor-coated wire that produces a cool, even glow similar...
Delivered by Wed 5 Aug
Adafruit Motor/Stepper/Servo Shield for Arduino v2 Kit [v2.3]
SKU: AF-1438 | Brand: Adafruit
The Adafruit Motor/Stepper/Servo Shield v2.3 is the upgraded successor to the original Motor Shield, delivering higher current, lower voltage drop, and a fully I2C-based design that frees up your Arduino's PWM pins. D...
Delivered by Thu 27 Aug
16mm Illuminated Pushbutton - Red Latching On/Off Switch
SKU: AF-1442 | Brand: Adafruit
A 16mm illuminated pushbutton with a built-in red LED and latching on/off action. Press once to switch on, press again to switch off — ideal for power switches, mode selectors, and control panels. The LED is wired in...
Delivered by Thu 27 Aug
5V Electromagnet - 5 Kg Holding Force - P25/20
SKU: AF-3873 | Brand: Adafruit
This 5V electromagnet provides 5kg of holding force when energised with approximately 5V DC (4–6V working range). When the power is switched off, the magnet loses its magnetic field, making it suitable for small contr...
Delivered by Thu 27 Aug
Little Bird L3G4200D based 3 Axis Gyro
SKU: LB-LR0401 | Brand: Little Bird
This compact module is built around the L3G4200D, a low-power 3-axis angular rate sensor with temperature data output. It measures the rate of change in rotation on the X, Y and Z axes, making it useful for motion sen...
Delivered by Wed 5 Aug
E-Textiles ADXL335 three axis acceleration sensor
SKU: LB-ETEXTILEADXL335 | Brand: Little Bird
This three-axis accelerometer is designed for e-textiles projects and is based on the ADXL335 MEMS accelerometer from Analog Devices. It can be used to detect joint movement, inclination and vibration.The board provid...
Delivered by Wed 5 Aug
Red Wire Wrap Wire on Spool 250m 30AWG
SKU: LB-LS0153R | Brand: Little Bird
Red Wire Wrap Wire on Spool 250m 30AWG Wire Wrapping Wire, 30 AWG External Material :PVC PVC insulation, Tinned copper conductor Diameter: 0.5 mm Inner diameter:0.25 mm Length:250 meters Heat-resistant: 80 degrees
Delivered by Wed 5 Aug
Soldering Iron Cleaner Sponge
SKU: LB-LS0305 | Brand: Little Bird
Soldering Solder Iron Tip Cleaner Steel Cleaning Wire Sponge BallIn order to reduce the temperature decreasing of soldering tip, you should not clean it with water.After you using the Sponge, it should be cleaned out ...
Delivered by Wed 5 Aug
Gravity: Analog Water Pressure Sensor
SKU: DF-SEN0257 | Brand: DFRobot
The Gravity Analog Water Pressure Sensor measures water or gas pressure and outputs a linear 0.5–4.5 V analogue signal proportional to the applied pressure (0–1.6 MPa). Using the DFRobot Gravity 3-pin interface, it co...
Delivered by Wed 5 Aug
Professional Silicone-Tip Solder Sucker
SKU: AF-1597 | Brand: Adafruit
This professional-grade solder sucker features a machined aluminium body and a replaceable silicone rubber tip that won't melt on contact with hot solder joints. The smooth spring-loaded action provides reliable, powe...
Delivered by Thu 27 Aug
SparkFun Qwiic Adapter
SKU: SF-DEV-14495 | Brand: SparkFun
The SparkFun Qwiic Adapter provides the perfect means to make any old I2C board into a Qwiic-enabled board. This adapter breaks out the I2C pins from the Qwiic connectors to pins that you can easily solder with you...
Delivered by Wed 5 Aug
JST-PH 2-Pin SMT Right Angle Connector
SKU: AF-1769 | Brand: Adafruit
This JST PH 2-pin SMT right-angle connector is a surface-mount header designed to accept standard JST PH 2-pin plugs. It's commonly used as a battery connector on microcontroller boards, LiPo chargers, and small elect...
Delivered by Wed 5 Aug
Adafruit Audio FX Sound Board - WAV/OGG Trigger - 16MB storage with 2x2W Amp
SKU: AF-2217 | Brand: Adafruit
The Adafruit Audio FX Sound Board with 2×2W Amp is a standalone audio trigger with a built-in stereo Class D amplifier — no Arduino or programming required. Simply drag and drop WAV or OGG sound files over USB, wire u...
Delivered by Thu 27 Aug
Adafruit GEMMA v2 - Miniature wearable electronic platform
SKU: AF-1222 | Brand: Adafruit
The Adafruit GEMMA V2 is a tiny, coin-sized wearable microcontroller board powered by an ATtiny85 processor. At just 28 mm in diameter, it's small enough to fit into any sewable or wearable project, and affordable eno...
Delivered by Wed 5 Aug
Gravity: Digital Piezo Disk Vibration Sensor
SKU: DF-DFR0052 | Brand: DFRobot
The DFRobot Vibration Sensor buffers a piezoelectric transducer that responds to strain changes by generating a measurable output voltage change which is propotional with the strength of vibration.So you can know the...
Delivered by Fri 14 Aug
TCS3200 RGB Color Sensor For Arduino
SKU: DF-SEN0101 | Brand: DFRobot
An RGB colour sensor breakout board based on the TAOS TCS3200 chip, with four built-in white LEDs for illumination. The TCS3200 can detect and measure a wide range of visible colours by converting light intensity to a...
Delivered by Fri 14 Aug
Gravity: Soil Moisture Sensor For Arduino
SKU: DF-SEN0114 | Brand: DFRobot
A resistive soil moisture sensor that reads the water content of surrounding soil by measuring electrical resistance between its two probes. Wetter soil conducts more easily (lower resistance), while dry soil conducts...
Delivered by Fri 14 Aug
Compare your options
All buying guides
The Teacher's Guide to micro:bit Robots: Kits, Buggies, and Robotics Compared
Compare micro:bit-compatible robot kits, buggies, and robotics platforms by age range, assembly difficulty, sensors, and curriculum fit — for classrooms, clubs, and home learners across Australia.
49 products compared
The Maker's Guide to Servos: Torque, Speed, and Control Compared
Compare hobby and industrial servos by torque, rotation range, and control type (PWM, digital, continuous) to pick the right motor for robotics, animatronics, and RC projects.
16 products compared
Title The Maker's Guide to ADCs: Resolution, Speed, and Interface Compared
Compare analogue-to-digital converters by bit depth, sample rate, and bus (I²C vs SPI) to pick the right chip for your Arduino, Raspberry Pi, or microcontroller project.
16 products compared