All Products

SKU: LB-LR0010 | Brand: Little Bird

Digital TempTemperature sensing module using an NTC thermistor. The output signal at ‘DO’ switches high when the preset (adjustable) temperature is reached. An analog output signal from the sensor is availab...

SKU: PI-IQA002 | Brand: Pimoroni

The IQaudIO Pi-DigiAMP+ is a HAT-compliant DAC and amplifier board for the Raspberry Pi, combining a high-quality 24-bit/192 kHz DAC with a 2×20W Class D stereo amplifier on a single board. Based on the Texas Instrume...

SKU: PI-PPMB00130 | Brand: Pimoroni

The Amp:bit is the easiest way to connect a speaker or headphones to your BBC micro:bit. It plugs directly onto the edge connector and provides a 3.5mm headphone jack, solder pads for a speaker, and a volume control w...

SKU: AF-3379 | Brand: Adafruit

The Feather 32u4 Bluefruit LE with Headers combines an ATmega32u4 microcontroller with a Bluetooth Low Energy module, USB connectivity, and LiPo battery charging — with standard headers pre-soldered so you can plug st...

SKU: TB-RN3444 | Brand: Little Bird

A 100 kΩ NTC (Negative Temperature Coefficient) thermistor in a radial dipped-epoxy package. These ceramic sensors change resistance rapidly with temperature, making them ideal for temperature measurement, compensatio...

SKU: AF-1381 | Brand: Adafruit

This breakout board is the ultimate companion for the VLSI VS1053B DSP codec chip. The VS1053 can decode a wide variety of audio formats such as MP3, AAC, Ogg Vorbis, WMA, MIDI, FLAC, WAV (PCM and ADPCM). It can al...

SKU: AF-2378 | Brand: Adafruit

The Arduino Pro Mini is SparkFun's minimal design approach to Arduino.  It's essentially a 5v Arduino that runs an 16 MHz bootloader on a super small, super thin board.  There are no connectors attached -...

SKU: PL-2463 | Brand: Pololu

The Vishay TSSP58P38 is a unique modulated IR receiver that is designed for IR brightness detection instead of data communication for remote control. This sensor can be used with a 38 kHz modulated IR emitter an...

SKU: SF-BOB-09110 | Brand: SparkFun

This is the breakout board for the thumb joystick. Pins are broken out to a 0.1" header and includes 4 mounting holes in the corners.

SKU: DF-SEN0068 | Brand: DFRobot

This is a piezoresistive force sensor. The harder you press, the lower the sensor's resistance. Pressing lightly, the resistance changes from infinite to ~300k. The sensor itself is thin and flexible, but the re...

SKU: SF-SEN-00242 | Brand: SparkFun

The Sharp GP2Y0A21YK is an infrared proximity sensor with an analogue voltage output that varies with distance — from 3.1 V at 10 cm to 0.4 V at 80 cm. It uses an IR emitter and position-sensitive detector to measure ...

SKU: DF-DFR0273 | Brand: DFRobot

Give your Arduino project a voice with this text-to-speech shield. Built around the IFLYTEK XFS5051CE speech synthesis chip, it converts text strings into spoken audio in English and Chinese, with support for both mal...

SKU: AF-3000 | Brand: Adafruit

Would you like to learn electronics, with an all-in-one board that has sensors and LEDs built in? Circuit Playground is here - and it's the best way to practice programming on real hardware with no soldering or sew...

SKU: AF-334 | Brand: Adafruit

If you've got a resistive touch screen that you'd like to use, you'll need this breakout! It has a fine pitch (0.5mm) connector soldered onto it and it's broken out into the 4 resistive wires of the panel. A petite...

SKU: AF-444 | Brand: Adafruit

Add a tiny joystick to your project with this PSP thumbstick. This is a replacement component for PSP1000's, but we think they'd make for a great little joystick/thumbstick add-on for a wearable, or portable pro...

SKU: SF-COM-10468 | Brand: SparkFun

The MSGEQ7 is a CMOS graphic equaliser IC that divides the audio spectrum into seven frequency bands: 63 Hz, 160 Hz, 400 Hz, 1 kHz, 2.5 kHz, 6.25 kHz, and 16 kHz. Each band is peak-detected and multiplexed to provide ...

SKU: AF-1804 | Brand: Adafruit

A durable 1/4" (6.35 mm) stereo in-line jack for building or repairing your own audio cables. The all-metal construction and flexible spring strain relief ensure a long-lasting, reliable connection. Simply solder you...

SKU: AF-1918 | Brand: Adafruit

An analog UV light sensor breakout based on the GUVA-S12SD photodiode, detecting the 240–370nm range covering UVB and most of the UVA spectrum. An on-board op-amp amplifies the tiny photodiode current to a readable vo...

SKU: DF-TEL0109 | Brand: DFRobot

WT8266-S1 Wi-Fi module is a low consumption, high performance embedded Wi-Fi network control module designed by Wireless-Tag. It can meet the IoT application requirements in smart power grids, building aut...

SKU: DF-KIT0194 | Brand: DFRobot

This expansion ecosystem transforms the UNIHIKER M10 single-board computer into a fully functional AIoT development station. By leveraging the modular DFRobot Gravity interface, the kit allows for the seamless integr...