All Products

SKU: AF-1757

Add a little sparkle to your wearable project with Adafruit LED Sequins. These tiny sewable LED boards are the simpler sibling of Flora NeoPixels — they display a single colour with no digital control needed, making them smaller and easier to use for many projects. Simply connect 3–6 VDC to the ...

SKU: AF-1657

Get started with Adafruit GEMMA with this lovely starter kit! Included is everything you need to make a basic project. There's a GEMMA board, four sewable bright RGB pixels, a battery holder and batteries, 2-ply conductive thread, alligator clips to help you test out your circuit, and a U...

SKU: AF-3675

The Adafruit Itsy Bitsy 32u4 3V packs the power of an Arduino Leonardo into a tiny 1.4" × 0.7" board. Built on the ATmega32u4 with native USB, it's perfect for compact projects that need a full set of GPIO pins without the bulk of a standard Arduino. Running at 3.3V and 8 MHz, the Itsy Bitsy 32u...

SKU: AF-1558

So, you want lots and lots of NeoPixels? And you want them for less? Not a problem! Here's a sheet of Breadboard-Friendly NeoPixel breakouts fresh from the (reflow) oven. Snap them off as you need 'em and save a pretty penny while you're at it.Each order comes with 25 pixels on a snap-apart sh...

SKU: AF-1559

So, you want lots and lots of NeoPixels? And you want them for less? Not a problem! Here's a sheet of Flora NeoPixels fresh from the (reflow) oven. Cut them off as you need 'em and save a pretty penny while you're at it.Each order comes with 20 pixels on a sheet. If you want a smaller number, ...

SKU: AF-3938

The NeoTrellis M4 Mainboard combines an ATSAMD51 Cortex M4 processor, a 4×8 grid of NeoPixel-lit elastomer button pads, stereo audio output, microphone input, and a triple-axis accelerometer into one compact, programmable board. Think of it as a button-mashing, light-flashing, tune-making powerho...

SKU: AF-3915

Keep your Circuit Playground Express safe in this snap-together acrylic enclosure. Designed by Ada-friend Mike Doell, this minimal but elegant case turns your board into an electronic snowflake shape with no tools required for assembly. The enclosure provides full access to all buttons, the slid...

SKU: AF-3928

The Adafruit CRICKIT for micro:bit is a robotics and electronics driver board designed for the BBC micro:bit. Plug your micro:bit into the 40-pin edge connector and start controlling motors, servos, solenoids, NeoPixels, capacitive touch sensors, and a speaker — all managed over I2C via the Adafr...

SKU: AF-4036

Have you put up with mainstream, uninspiring, low-tech tree ornaments for too long? This season why not deck the halls with codes of holly? This DIY Ornament Kit is just the right size (6 cm diameter) for a Circuit Playground Express, 500mAh LiPoly battery, and however you'd like to dress up ...

SKU: AF-3954

Upgrade your button-pad projects with full-colour NeoPixel backlighting. The NeoTrellis RGB Driver PCB is a 4×4 keypad controller with 16 NeoPixels and an onboard seesaw I2C chip that handles both button scanning and LED driving — all over plain I2C, no NeoPixel pin management required. The boar...