All Products

SKU: SF-SEN-15901

This Weather Meter Kit provides the three core sensors for a DIY weather station: an anemometer (wind speed), a wind vane (wind direction), and a rain gauge. All three sensors use passive magnetic reed switches rather than active electronics, making them simple to interface with any microcontroll...

SKU: SF-BOB-13021

This is the SparkFun RJ45 MagJack Breakout, a simple board that will provide you with a way to put an ethernet port into your breadboard. The SparkFun RJ45 MagJack Breakout is the same one found in our very own mbed Starter Kit and breaks out each pin from the ethernet jack. This rev of the br...

SKU: SF-BOB-09816

This is a simple 5V Op Amp breakout board, set up as a 2-stage amplifier with a gain of 100 (gain of 10 for each stage). The on-board trim pot sets the signal level between the stages, not the feedback path. The bandwidth is set to 15.9kHz by a pair of feedback capacitors, or over 100kHz with the...

SKU: SF-ROB-09454

The SparkFun QRE1113 Line Sensor Breakout (Digital) is a compact IR reflectance sensor board that outputs a digital signal based on surface reflectivity. It uses a capacitor discharge circuit — the faster the 10 nF capacitor discharges, the more reflective the surface. This makes it straightforwa...

SKU: SF-BOB-12731

This is the SparkFun USB to Serial Breakout for the FT232RL, a small board with a built in USB to serial UART interface. This little breakout is built around the FT232RL IC from FTDI, with an internal oscillator, EEPROM, and a 28-pin SSOP package this is a serious little chip. With this version...

SKU: EF-EF05010 · MPN: EF05010

A green LED module from the ELECFREAKS PlanetX sensor range, designed for use with micro:bit and the Nezha expansion board. The RJ11 connector makes it simple to plug in — no soldering or breadboard required. Control brightness via analogue input, create flashing patterns, or combine with other ...

SKU: SF-BOB-13830

The CY7C65213 USB to UART serial breakout is designed to provide users with a means to access all available I/O pins on the IC, and to provide a 6-pin UART header that is compatible with other SparkFun breakout boards. This breakout has a microUSB connector and other support circuitry to get t...

SKU: SF-KIT-15367

The SparkFun Qwiic Kit for Raspberry Pi provides everything you need to start using I2C sensors and displays with your Raspberry Pi via the Qwiic connector system. The kit includes a Qwiic HAT that adds four Qwiic connectors to your Pi's GPIO header, along with three sensor/display breakouts and ...

SKU: SF-SEN-12064

The HTU21D is a low-cost, easy to use, highly accurate, digital humidity and temperature sensor. This sensor is ideal for environmental sensing and data logging and perfect for a weather stations or humidor control systems. All you need is two lines for I2C communication and you’ll have relative ...

SKU: SF-SEN-16466

A complete environmental sensor breakout based on the Bosch BME680, combining gas sensing (VOC), temperature, humidity, and barometric pressure in a compact 25.4 × 25.4mm (1" × 1") board. The gas sensor detects a wide variety of volatile organic compounds for indoor air quality monitoring. Commu...

SKU: EF-EF05045

The Smart AI Lens kit for micro:bit brings machine vision and AI capabilities to your classroom or maker project. Powered by a K210 processor, the AI Lens camera module can recognise faces, track objects and colours, identify pattern cards, and even learn to recognise custom objects with a single...