LIS3DH Micro Triple Axis Accelerometer Breakout (Qwiic)

Jargon buster

Plain-language definitions for the technical terms used above.

12-bit resolution

12-bit resolution means the sensor’s measurement is divided into 4096 possible digital values. Higher resolution can make small changes in motion or tilt easier to detect, as long as the sensor range and noise are suitable for the project.

3DoF

3DoF means “three degrees of freedom,” usually measuring motion along three axes: X, Y and Z. For this accelerometer, it tells you the board can sense acceleration and tilt in three directions, but not rotation like a gyro would.

breakout

A breakout is a small circuit board that makes a tiny or hard-to-solder component easier to connect to with standard pins. It matters because this OLED module can be wired into a microcontroller project without needing to solder directly to the display’s fine contacts.

FIFO

FIFO stands for “first in, first out” and is a small memory buffer inside the sensor that stores recent readings in order. This matters because it can help capture motion data without the microcontroller needing to read the sensor every single instant.

I2C

I2C is a two-wire communication bus used by many sensors and small modules. It matters because several I2C devices can share the same two wires, but each device needs a compatible address and your controller must support I2C.

LIS3DH

A specific low-power 3-axis accelerometer chip made by STMicroelectronics. Knowing the chip part number helps you find the correct datasheet, libraries, wiring details, and limits such as its safe voltage range.

Motion detection

A camera feature that checks the image for changes that suggest something has moved. It matters because your project can use movement as a trigger instead of constantly saving or processing every frame.

PTH

Plated through-hole means the pin holes are metal-lined so solder connects the pad on both sides of the board. It is useful for connectors and headers that need a strong mechanical and electrical connection.

Qwiic

Qwiic is a plug-in connector system for I2C devices that uses small 4-pin cables, so you can connect compatible sensors without soldering. It matters because your controller or adapter also needs Qwiic, or you will need a cable or breakout to wire it up.

SPI

A fast serial communication bus often used for displays, memory cards, and sensors. It matters because SPI devices need specific pins for clock and data, plus a separate chip-select line for each device.