SparkFun
SparkFun Electric Imp Breakout
All Products
Breakouts
New Arrivals
SparkFun
Microcontrollers & Development Boards
IoT Development Boards
Wi-Fi Modules
Connectivity
Arduino Wireless and IoT
$24.95
|
Only 1 left
If you aren’t familiar with the Electric Imp, it essentially provides an easy, integrated way to connect almost any hardware device both to other devices and...
Get notified when back in stock
Estimated Delivery
Arrives
Disclaimer
Secure checkout
If you aren’t familiar with the Electric Imp, it essentially provides an easy, integrated way to connect almost any hardware device both to other devices and to internet services.
The SparkFun Electric Imp Breakout Board allows you to explore the capabilities of the Imp by providing standard 0.1" headers to solder to as well as the necessary CryptAuthEE IC to identify your prototype to the Imp Cloud service!
The SparkFun Electric Imp Breakout Board allows you to explore the capabilities of the Imp by providing standard 0.1" headers to solder to as well as the necessary CryptAuthEE IC to identify your prototype to the Imp Cloud service!
This is just the development board, so you’ll need to buy the Imp separately, check the related items below!
Note: If you want to use the mini-USB or battery inputs for power, you will need to populate the 3-pin jumper and set it to either ‘BAT’ or ‘USB’. Otherwise, you can just simply power the board using VIN and GND without the use of a jumper.
Jargon buster
Plain-language definitions for the technical terms used above.
- breakout
- A breakout board carries a small or fine-pitched component and brings its connections out to standard, breadboard- and header-friendly pins. Describing a part as a breakout means it can be wired into a project without soldering directly to the component's tiny contacts.
- GND
- GND is the ground or reference connection (0 V) for a circuit. When connecting two devices together, their grounds must be joined so both agree on what counts as a low or high signal.
- Headers
- Rows of connector contacts on a fixed pitch (commonly 2.54 mm) used to link a board to a breadboard, jumper wires, or another board. They come as male pin headers and female socket headers; when a module ships with pre-soldered headers it can be used straight away, whereas bare pads require soldering the pins yourself.
Find this product in
All Products
Arduino Wireless and IoT
Breakouts
Microcontrollers & Development Boards
New Arrivals
SparkFun
Connectivity
Related Tutorials
Free guides on learn.littlebird.com.au
