Adafruit
JST PH 3-Pin to Male Header Cable - 200mm
The JST PH 3-Pin to Male Header Cable converts a JST PH 3-pin connector into three individual colour-coded wires, each terminated with a 0.1" (2.54 mm) male ...
Get notified when back in stock
The JST PH 3-Pin to Male Header Cable converts a JST PH 3-pin connector into three individual colour-coded wires, each terminated with a 0.1" (2.54 mm) male header pin. It's ideal for extending sensor or LED connections to a breadboard or development board.
At 200 mm long, this cable provides enough reach for prototyping while keeping wiring tidy. The colour-coded wires make it easy to identify signal, power, and ground lines at a glance.
Key Features
- JST PH 3-Pin Connector – Standard 2.0 mm pitch, widely used on sensors and small modules
- Male Header Pins – 0.1" (2.54 mm) pitch for direct breadboard or header insertion
- Colour-Coded Wires – Easy identification of each conductor
- 200 mm Length – Suitable for prototyping and bench setups
Ideal For
- Connecting JST PH sensors or LEDs to breadboards
- Prototyping with development boards that use 0.1" headers
- Extending connections on projects using Adafruit HalloWing or similar boards
Package Contents
- 1× JST PH 3-Pin to Male Header Cable (200 mm)
Jargon buster
Plain-language definitions for the technical terms used above.
- Headers
- Rows of connector contacts on a fixed pitch (commonly 2.54 mm) used to link a board to a breadboard, jumper wires, or another board. They come as male pin headers and female socket headers; when a module ships with pre-soldered headers it can be used straight away, whereas bare pads require soldering the pins yourself.
- JST PH
- A small keyed plug-and-socket connector with 2 mm pin spacing, often used for low-power electronics connections. You need the correct JST PH cable, and its current rating limits how much power should be passed through it.
- LED
- A light-emitting diode (LED) is a small electronic component that emits light when current flows through it in the correct direction. Because it only conducts one way, its polarity matters, and a through-hole LED must be soldered the correct way around to light up.
- pH
- A measure of how acidic or alkaline a liquid is, on a scale from 0 to 14 where 7 is neutral, lower is acidic and higher is alkaline. When a probe or sensor quotes a pH range and accuracy, check they cover the readings your project needs.
Find this product in
Brands
Prototyping & Wiring
Related Tutorials
Free guides on learn.littlebird.com.au
