Arduino RS232 to TTL Converter with DB9 (MAX202)

Jargon buster

Plain-language definitions for the technical terms used above.

baud

Baud is the signalling rate of a serial connection, often used as the speed setting for UART communication. Matching the baud rate matters because both connected devices must use the same setting for readable data.

capacitance

Capacitance is the amount of electrical charge a capacitor can store, usually measured in farads such as uF. Choosing the right capacitance value matters because it affects how well a circuit filters power, handles timing, or stores short bursts of energy.

GND

GND is the ground or reference connection (0 V) for a circuit. When connecting two devices together, their grounds must be joined so both agree on what counts as a low or high signal.

GPS

The US satellite navigation system used by GNSS receivers to calculate position and time. Support for GPS is important because it is widely available and often used together with other constellations for more reliable positioning.

RS-232

RS-232 is an older serial communication standard that uses higher, inverted signal voltages (typically around plus or minus 3 to 15 volts) rather than the low logic levels of modern microcontroller pins. When connecting RS-232 equipment to a microcontroller, you usually need an RS-232 transceiver or level converter rather than wiring it directly, or you risk damaging the pins.

STM32

STM32 is a family of microcontroller chips commonly used in embedded electronics. Knowing a product uses an STM32 can help when looking at firmware updates, pin connections, or low-level serial control options.