SparkFun

SKU: SF-COM-11409 | Brand: SparkFun

This 20mm 4-digit 7-segment display in white is a mid-size option — large enough to read from a distance but compact enough to fit in most enclosures. The common-cathode display features four 7-segment digits with one...

SKU: SF-COM-11408 | Brand: SparkFun

This 20mm 4-digit 7-segment display in blue is a mid-size option — large enough to read from a distance but compact enough to fit in most enclosures. The common-cathode display features four 7-segment digits with one ...

SKU: SF-DEV-11224 | Brand: SparkFun

This is the new Arduino Uno R3. In addition to all the features of the previous board, the Uno now uses an ATmega16U2 instead of the 8U2 found on the Uno (or the FTDI found on previous generations). This allows for fa...

SKU: SF-WRL-13225 | Brand: SparkFun

The SparkFun XBee Explorer Serial is an RS232 serial base unit for configuring and communicating with XBee modules. Compatible with all XBee modules including Series 1, Series 2.5, standard, and Pro versions. Simply p...

SKU: SF-ROB-13177 | Brand: SparkFun

The Micro Gripper Kit B is a compact robotic gripper designed for small-scale robotics projects. It works with any sub-micro size Hitec servo (not included) and features the standard 0.77" hub mount pattern for easy i...

SKU: SF-PRT-10927 | Brand: SparkFun

These nylon standoffs are 3/8" long and tapped for a 4-40 screw. These are great for mounting your board in an enclosure, or just getting it up off the table. The black nylon will give your project a very sessy loo...

SKU: SF-TOL-10865 | Brand: SparkFun

There’s nothing worse than getting ready for a good hack and then realizing that you can’t even get the box open because you don’t have the right screwdriver. Sure, we all have a few Phillips-head drivers and maybe a ...

SKU: SF-PRT-13054 | Brand: SparkFun

A 2×20 shrouded (boxed) header designed to match the Raspberry Pi GPIO pinout. It provides a keyed, polarised connection point so you can run a ribbon cable from your Pi's GPIO to a breakout board, HAT prototype, or c...

SKU: SF-DEV-10587 | Brand: SparkFun

Do you ever wish your Arduino was more musically talented? Or maybe your project could use some cool sound effects. The SparkFun Musical Instrument Shield is an easy way to add great sounding MIDI sound to your next A...

SKU: SF-DEV-10524 | Brand: SparkFun

The name says it all on this one. An ATmega328 in DIP package, pre-loaded with the Arduino Optiboot (Uno 16MHz) Bootloader. This will allow you to use Arduino code in your custom embedded project without having to ...

SKU: SF-PRT-10371 | Brand: SparkFun

This is a simple six wire cable. Great for jumping from board to board or just about anything else. There is a 6-pin JST RE connector on both ends. These are simple jumper wires used on standard 0.1" breakaway headers...

SKU: SF-COM-10001 | Brand: SparkFun

Knobs are a great way to finish off your project and make it easier to adjust the level of your death ray. This knob mates to a 0.25" shaft. The knob slides onto the potentiometer and holds tightly with a strong frict...

SKU: SF-SEN-09836 | Brand: SparkFun

This new version adds 2 standoff holes as well as an extra decoupling capacitor. The ADXL345 is a small, thin, low power, 3-axis MEMS accelerometer with high resolution (13-bit) measurement at up to +-16 g. Digital...

SKU: SF-PRT-09835 | Brand: SparkFun

This is a simple 4 cell AA battery holder. The 5 inch cable is terminated with a standard 5.5x2.1mm, center positive barrel jack connector. The connector mates with the barrel jack on the Arduino (among a numbe...

SKU: SF-SEN-09673 | Brand: SparkFun

A compact force sensitive resistor (FSR) from Interlink Electronics with a 4 mm (0.16″) diameter active sensing area. The resistance changes based on applied pressure — from over 1 MΩ with no pressure down to approxim...

SKU: SF-COM-09592 | Brand: SparkFun

LEDs - those blinky things. A must have for power indication, pin status, opto-electronic sensors, and fun blinky displays. This is a very basic 5mm LED with a green lens. It has a typical forward voltage of 2.0V and ...

SKU: SF-SEN-09570 | Brand: SparkFun

Melexis' MLX90614ESF-BAA is an infrared thermometer designed for non-contact temperature sensing. An internal 17-bit ADC and a powerful DSP contribute to the MLX90614’s high accuracy and resolution. It has a huge numb...

SKU: SF-PRT-25761 | Brand: SparkFun

A compact aluminium heatsink with self-adhesive backing for easy peel-and-stick installation. Efficiently draws heat away from electronic components including ICs, voltage regulators, and processor chips to promote op...

SKU: SF-CAB-25596 | Brand: SparkFun

With the SparkFun Qwiic Connect System expanding every day, we want to make sure it becomes as accessible as possible but we understand there are other systems that can compliment it out there. The Qwiic to STEMMA Ada...

SKU: SF-TOL-25566 | Brand: SparkFun

Use this precision Phillips #00 screwdriver for DIY or professional small electronics repair. The Phillips #00 screw is the most commonly used fastener in the internals of consumer electronics, game consoles, laptops,...